Results 81 to 90 of about 997 (171)
Selected Properties of the Surface Layer of C45 Steel Parts Subjected to Laser Cutting and Ball Burnishing. [PDF]
Materials (Basel), 2020 Skoczylas A, Zaleski K.
europepmc +1 more source
Metalurgija, 2013 The article discusses problems related to the influence of rolling processes on the process of closing of internal discontinuities in continuous castings during rolling in two types of shape grooves.
M. Knapiński +3 more
doaj
The Influence of the Depth of Cut in Single-Pass Grinding on the Microstructure and Properties of the C45 Steel Surface Layer. [PDF]
Materials (Basel), 2020 Szkodo M +4 more
europepmc +1 more source
Research of boride layers growth kinetics on C45 carbon steel
Metalurgija, 2012 This study reports an evaluation of borides formed on C45 steel. Pack boronizing has been carried out in temperature range 870 – 970 °C with durations 4 – 8 h. Average thickness of boride layers ranges from 60, 6 to 181, 2 µm. Through application of basic laws of diffusion, values of frequency factor and activation energy have been determined and ...
Kladarić, Ivica +2 more
openaire +1 more source
Journal of KONES. Powertrain and Transport, 2014 Justyna Molenda, Adam Charchalis
openaire +1 more source
Dilatometric and hardness analysis of C45 steel tempering with different heating-up rates
Metalurgija, 2012 Modelling of technological processes of heat treatment or welding, involving multiple heat source transitions, requires considering the phenomenon of tempering.
A. Kulawik, J. Winczek
doaj
The wear resistance of electrospark coatings on steel C45 when operating with counterbodies of different steels [PDF]
, 2015 In this work the tribological properties of coatings molybdenum, chromium, and stellite B3K obtained by electrospark alloying method on 45steel were studied. Tests data with rollers made of steel C45 HRC 50-52 and steel 30CrMnSiA HRC 38-42 showed, that molybdenum coatings were the most wear resistant.
Agafii, V.I. +5 more
openaire
Effect of Centrifugal Shot Peening on the Surface Properties of Laser-Cut C45 Steel Parts. [PDF]
Materials (Basel), 2019 Skoczylas A, Zaleski K.
europepmc +1 more source
Optimizing Wire-EDM for C45 Steel Spur Gear Machining
WSEAS TRANSACTIONS ON APPLIED AND THEORETICAL MECHANICSThis research focuses on identifying the optimal Wire-EDM parameters to enhance the quality and precision of machining external spur gears with straight teeth using C45 steel. The study investigates three key parameters—wire feed rate (n, mm/s), short-circuit ratio (s), and wire compensation (f, mm)—employing the Box-Behnken experimental design ...
openaire +1 more source
Quality Analysis of Cutting Steel Using Laser
Mokslas: Lietuvos Ateitis, 2012 The article explores the quality dependence of the edge surface of steel C45 LST EN 10083-1 obtained cutting the material using laser on different cutting regimes and variations in the thickness of trial steel.
Vladislav Markovič
doaj