Results 101 to 110 of about 7,757 (214)
Exploiting CO2‐Derived Carbon in Lithium‐Ion Batteries
Advanced Energy and Sustainability Research, Volume 7, Issue 1, January 2026.In this work, a carbon nanomaterial (CNM) extracted from CO2 reduction treatment is used as the conductive additive in lithium‐ion battery graphite anodes and LiFePO4 cathodes. The electrodes are produced by casting, using both sodium alginate as a green, water‐soluble, alternative binder.
Nicolò Albanelli +8 more
wiley +1 more source
Applied SciencesWeld surfacing is the process of applying a layer of metal to the surface of metal objects by simultaneously melting the substrate. As a result of this process, the metal content of the padding weld can be as high as several tens of percents.
Sylwia Bazychowska +2 more
doaj +1 more source
Bond characterization between concrete substrate and repairing SFRC using pull-off testing [PDF]
, 2005 In the last years, an emerging repair and strengthening technique for concrete slabs has been used, consisting of applying a thin layer of steel fibre reinforced concrete(SFRC) onto the slabs.
Barros, Joaquim A. O. +2 more
core +1 more source
Geometric and material nonlinear analysis of imperfect circular hollow section (CHS) columns : steeel tubes and concrete filled tubes [PDF]
, 2009 The comparison between theoretical predictions and design curve predictions of the critical stresses, for a wide range of slenderness ratio, is valid and useful.
Barros, Rui +2 more
core
LubricantsMetal machining production faces a myriad of demands encompassing ecology, automation, product control, and cost reduction. Within this framework, an exploration into employing a direct inspection of the machined area within the work zone of a given ...
Jozef Jurko +3 more
doaj +1 more source
Metalurgija, 2016 This study presents results of the examinations aimed at determination of rheological properties of selected grades of medium and high-carbon steel grades ( C45 and C72D).
K. Laber +3 more
doaj
Rapid optimization of laser quenching process based on bp neural network
Metalurgija, 2023 The rapid optimization of laser quenching process parameters were studied. First of all, the experiment is carried out by orthogonal method, which achieves the purpose of finding the influence law of process parameters with a small number of samples ...
Y. Y. Zhang, Y. X. Chen
doaj
Experimental study of rotary compression for hollow parts
Metalurgija, 2015 The paper describes rotary compression, a new method for producing hollow parts. First, a prototype machine fort his process is described. The machine was designed and constructed at the Lublin University of Technology. Next,selected experimental results
Z. Pater, J. Tomczak, T. Bulzak
doaj
Journal of Mechanical Engineering and SciencesThe surface roughness, Ra of mechanical products is an important parameter commonly used to evaluate the surface quality of a part after machining.
Cong Chi Tran, Van Tuu Nguyen
doaj +1 more source
Improvement of structure and quality of nanoscale multilayered composite coatings, deposited by filtered cathodic vacuum arc deposition method [PDF]
This article studies the specific features of cathode vacuum arc deposition of coatings used in the production of cutting tools. The detailed analysis of the major drawbacks of arc-Physical Vapour Deposition (PVD) methods has contributed to the ...
Aksenenko, AY +5 more
core +1 more source