Results 121 to 130 of about 7,757 (214)
Journal of KONES. Powertrain and Transport, 2014 Justyna Molenda, Adam Charchalis
openaire +1 more source
Influence of the Wall Thicknesses on the Joint Quality During Magnetic Pulse Welding in Tube-to-Tube Configuration [PDF]
, 2016 The implementation of multi-material concepts, for example, in automotive engineering or aerospace technologies, requires adequate joining techniques.
Bellmann, J. +6 more
core
The Influence of the Depth of Cut in Single-Pass Grinding on the Microstructure and Properties of the C45 Steel Surface Layer. [PDF]
Materials (Basel), 2020 Szkodo M +4 more
europepmc +1 more source
Multi-Objective Optimization of Finishing Milling of C45 Steel using Factorial Design
Engineering, Technology & Applied Science ResearchThis study presents an innovative approach to optimizing the milling process of C45 steel using a factorial design of experiments. The impact of key technological parameters, including cutting speed (Vc), feed per tooth (fz), depth of cut (ap), and lubrication conditions (dry and flood), on surface roughness (Ra) and Material Removal Rate (MRR) was ...
Pham Ngoc Linh +3 more
openaire +1 more source
Co-movements in commodity prices: a note based on network analysis [PDF]
This paper analyses co-movements in a wide group of commodity prices during the time period 1992-2010. Our methodological approach is based on the correlation matrix and the networks inside.
Benno Torgler +3 more
core
Friction of PA6 and peek composites in the light of their surface characteristics [PDF]
, 2014 Our present work is connected to a broad tribology research project with different polymer composites on PA6, POM, PET and PEEK matrix and targeted to create a detailed map of tribological features.
Szakál, Zoltán, Zsidai, László
core
Influence of Different Material Models on the Result of Numerical High Speed Cutting Simulations [PDF]
, 2004 Extreme conditions for the workpiece and the tool can occur in high speed cutting processes. Temperatures above 1000 °C at very high strains over 3 and strain rates near 105 1/s are not unusual.
Halle, T., Meyer, L. W.
core
Effect of Centrifugal Shot Peening on the Surface Properties of Laser-Cut C45 Steel Parts. [PDF]
Materials (Basel), 2019 Skoczylas A, Zaleski K.
europepmc +1 more source
Quality Analysis of Cutting Steel Using Laser
Mokslas: Lietuvos Ateitis, 2012 The article explores the quality dependence of the edge surface of steel C45 LST EN 10083-1 obtained cutting the material using laser on different cutting regimes and variations in the thickness of trial steel.
Vladislav Markovič
doaj
Engineering ReportsGrinding in conventional air atmospheres is affected by the formation of oxide and passivation layers, which alter friction, material removal behavior, and surface integrity.
Berend Denkena +3 more
doaj +1 more source