Results 91 to 100 of about 180,619 (295)
Kinetics of Moisture Sorption and Reverse Bias Degradation in Chip Tantalum Capacitors [PDF]
Exposure of chip MnO2 tantalum capacitors to humid environments might result in increased ESR, leakage currents, and first turn-on failures. However, there is a lack of literature data on the effect of moisture on reverse bias behavior of the parts.
Teverovsky, Alexander
core +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
IET NanodielectricsContinuous three‐dimensional BaTiO3 (3DBT) ceramic network was prepared by the sol‐gel method using cleanroom wipers as the template. Subsequently, flexible 3DBT/polyvinyl alcohol‐boron nitride nanosheets (PVA‐BNNS) composite dielectric films were ...
Yongzhi Yang +7 more
doaj +1 more source
Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC
Advanced Engineering Materials, EarlyView.ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko +2 more
wiley +1 more source
IET Generation, Transmission & DistributionThis research introduces a novel damped alternating current (DAC) testing methodology, which integrates an enhanced DAC generator with a pulse‐based distributed partial discharge (PD) detection technique.
Yuxin Lu +10 more
doaj +1 more source
Design and simulation of zipping variable capacitors
, 2007 Variable capacitors are essential for building tunable RF systems. We present here the design and simulation of novel zipping variable capacitors with a high permittivity dielectric layer. Two modelling techniques are presented: finite element simulation
Holmes, A.S., Pu, S.H, Yeatman, E.M.
core
Advanced Engineering Materials, EarlyView.ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source
Single and two capacitor (solenoid) paradox (studied at the realistic circuits)
, 2018 We study remarkable two (single) capacitor paradox and we introduce analogously a new two solenoids (inductive coils) paradox at experimentally and theoretically well-known electrical circuits with realistic electrical resistances.
Pankovic, Vladan
core
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Capacitance Estimation for Piezoelectric Actuators, an Artificial Intelligence Approach
IET Science, Measurement & TechnologyThis research aimed to investigate charge‐based position estimation/control of piezo‐actuated nanopositioning systems using a data‐driven approach. In the analysis of these systems, piezoelectric actuators are widely approximated as capacitors with a ...
Zohreh Rafiei Samani +5 more
doaj +1 more source