Results 21 to 30 of about 257,287 (291)
Elimination of misrun and gas hole defects of investment casting TiAl alloy turbocharger based on numerical simulation and experimental study [PDF]
China Foundry, 2020 Casting technology of thin-wall TiAl alloy turbochargers was studied by investment casting and numerical simulation. Misruns and gas holes were the main defects observed in preliminary work due to the poor fluidity of alloy, and to gas entrapment.
Jun Zhao, Zhi-yong Zhang, Shi-bing Liu
doaj +1 more source
Applied Sciences, 2022 With rising electricity prices, industries are trying to exploit opportunities to reduce electricity costs. Adapting to fluctuating energy prices offers the possibility to save electricity costs without reducing the performance of the production system ...
Stefan Roth +3 more
doaj +1 more source
Materials Research Express, 2020 Cu _45 Mn _25 Al _15 Fe _5 Cr _5 Ni _5 high entropy alloy was prepared using casting route. Detailed microstructural analysis revealed the formation of dendritic structure in the as-cast sample.
K A Abdelghafar +3 more
doaj +1 more source
A Modular Car Body for Sustainable, Cost-Effective, and Versatile Vehicle Development
Technologies, 2021 Availability, sustainability, and functionality pose particular challenges for the value chain of individual mobility. Therefore, in this work, the typical value chain is broken up and the traditional approaches are extended with an open-source ...
Christoph Hartmann +4 more
doaj +1 more source
Development Workflow for Manifolds and Fluid Components Based on Laser Powder Bed Fusion
Applied Sciences, 2021 Through its unique characteristics, additive manufacturing yields great potential for designing fluid components with increased performance characteristics.
Nicolas Rolinck +4 more
doaj +1 more source
Analysis of Gap Formation in the Casting of Energetic Materials [PDF]
, 2007 The problem of undesirable separation of the cast material from the mold in the casting of energetic materials is investigated. Comprehensive models are developed to simulate the heat and mass transfer processes during melt casting of energetic materials,
Singh, S. K. +3 more
core +1 more source
The improvement of aluminium casting process control by application of the new CRIMSON process [PDF]
, 2012 All The traditional foundry usually not only uses batch melting where the aluminium alloys are melted and held in a furnace for long time, but also uses the gravity filling method in both Sand Casting Process (SCP) and Investment Casting Process (ICP).
Jolly, Mark R. +2 more
core +1 more source
Energy efficiency improvement by implementation of the novel CRIMSON aluminium casting process [PDF]
, 2011 Foundry engineers in the traditional foundry usually regard the quality of casting component as the most important issue and leave the energy saving or energy efficiency as the subsidiary one. This frequently causes disproportionate energy consumption as
Jolly, Mark R. +3 more
core +1 more source
Vanadium microalloyed steel for thin slab casting and direct rolling [PDF]
, 2005 Vanadium microalloyed steels with high yield strength (ยป600 MPa), good toughness and ductility have been successfully produced in commercial thin slab casting plants employing direct rolling after casting.
Mitchell, P.S., Baker, T.N., Li, Y.
core +3 more sources
Optimization of Heavy Reduction Process on Continuous-Casting Bloom
Metals, 2022 Heavy reduction (HR) is an effective technique to control V segregation in continuous casting bloom, but the effect of segregation improvement is limited by the parameters such as reduction position and reduction amounts.
Bao Yang +5 more
doaj +1 more source