Results 141 to 150 of about 226,475 (267)

Leveraging Symbolic Artificial Intelligence and Fuzzy Logic for Materials Science: A Review of Methods, Challenges, and Applications to Scarce and Imperfect Experimental Data

Advanced Engineering Materials, EarlyView.
This article explores the transformative potential of symbolic artificial intelligence (AI) in the field of materials science, particularly in leveraging experimental data. The article presents several symbolic AI models and discusses their applications in materials science.
Ahmed Amrani, Mohamed‐Ali Belloum, Laurence Boudet, Valentin Fouillard, Edwin Friedmann, Guillaume Lacharme, Ali Mahmoud, Jean‐Philippe Poli   +7 more
wiley   +1 more source

Innovative Designs of Multimodal Imaging Based on Radionuclide, Quantum, and Cargo-Loaded Nanoplatform Emitters Towards Enhanced Energy-Matter Interactions for Photonics and Bioassays. [PDF]

Materials (Basel)
Romero MR, Quinteros DA, Bracamonte AG.
europepmc   +1 more source

Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning

Advanced Engineering Materials, EarlyView.
The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley   +1 more source

What Counts in General Chemistry? An Exploratory Look at What Was Emphasized and Rewarded on General Chemistry Exams Across the United States. [PDF]

J Chem Educ
Greco NC, Ellias NJ, Stowe RL.
europepmc   +1 more source

Investigating the Low‐Temperature Phase Stability of the Binary Ta–W System

Advanced Engineering Materials, EarlyView.
Atomistic simulations show that the binary Ta–W system forms ordered intermetallic phases, B2‐TaW and D03‐TaW3, as 0 K ground states. Configurational entropy, however, lowers the free energy of the disordered bcc solid solution, which becomes the stable phase above about 400 K.
Klemens Lechner, Anna Sophie Jelinek, Velislava Terziyska, Peter Wagatha, Wolfram Knabl, Christian Mitterer, Helmut Clemens, David Holec   +7 more
wiley   +1 more source

Entropy plateaus, combinatorial degeneracy, local moments, and heavy-fermion mass renormalization in magic-angle graphene. [PDF]

Nat Commun
Zhang Z, Wu S, Călugăru D, Hu H, Taniguchi T, Wanatabe K, Bernevig AB, Andrei EY.   +7 more
europepmc   +1 more source

Toward Full Interoperability in Materials Science: Integrating Workflows With Knowledge Graphs

Advanced Engineering Materials, EarlyView.
The connection of conceptual workflow design, portable execution, and ontology‐based semantics leading to provenance‐rich knowledge graphs are main contributors to interoperability in materials science and a prerequisite to AI‐assisted orchestration and for interoperable Materials Acceleration Platforms.
Jan Janssen, Osamu Waseda, Bernd Bayerlein, Simon Stier, Steffen Brinckmann, Abril Azócar Guzmán, Sarath Menon, Matthias A. Popp, Jesper R. Pedersen, Ivano E. Castelli, Jörg Waitelonis, Wolfgang Wenzel, Jörg Neugebauer, Jörg Schaarschmidt, Tilmann Hickel   +14 more
wiley   +1 more source

Effects of Mg on Microstructure and Solidification of a Hypereutectic Zn–8 wt.%Al Alloy

Advanced Engineering Materials, EarlyView.
An appreciable set of results involving thermal data, microstructure, chemical composition, and microstructural growth laws is reported for ZnAlMg alloys. Such results demonstrate that ZnAlMg alloys have high potential for applications in automotive self‐lubricating components, batteries, and electrical systems.
Raí B. de Sousa, Jeverton L. Paixão, Daylla S. Silva, Bruno S. Sobral, Mucio D. de Medeiros, José E. Spinelli, Bismarck L. Silva   +6 more
wiley   +1 more source

Designer Moiré Quantum Materials Enabled by Freestanding Oxide Membranes in Twisted and Hybrid Bilayers. [PDF]

Adv Sci (Weinh)
Kaur P, Rahul, Yang JC.
europepmc   +1 more source

Cryogenic Deformation Behavior of TiAl and Insights Into Embrittlement After High‐Temperature Exposure Combined With Secondary Ion Mass Spectroscopy of Near Surface Chemistry

Advanced Engineering Materials, EarlyView.
Near‐surface deuterium enrichment profiles for different microstructural types of TiAl after exposure at 700 °C in a heavy water‐containing environment. The deuterium levels are significantly higher than expected from natural occurrence, indicating that the heavy water dissociated during the exposure treatment and entered the specimens.
Jonathan D. H. Paul, Alexander Welle, Dirk Matthiessen, Michael Oehring, Fritz Appel, Florian Pyczak   +5 more
wiley   +1 more source