Results 61 to 70 of about 75,978 (312)
Advanced Materials, EarlyView.A hierarchical hydrogel evaporator with a thin, porous photothermal layer of fused core–shell carbon‐polymer nanospheres enables ultrafast interfacial solar evaporation with minimized heat loss and sufficient water supply. Directional advection‐dominated brine transport, coupled with Marangoni‐driven interfacial flow, drives salt away from the active ...
Haokun Shen +11 more
wiley +1 more source
Numerical study on failure process and ultimate state of steel bearing under combined load
Heliyon, 2020 The limit state and deformation performance of steel bearing under seismic load is one of the most critical points to consider the effective or rational design of bridge against strong ground motion.
Hagere Alemayehu Gibe +2 more
doaj +1 more source
Structural Correctness of Planning Processes in Building Engineering [PDF]
, 2004 The planning of projects in building engineering is a complex process which is characterized by a dynamical composition and many modifications during the definition and execution time of processes.
König, Markus +5 more
core +1 more source
Rate-Dependent Behavior of Transverse Welded Lap Joints at Elevated Temperatures [PDF]
, 2021 This paper presents key findings of an experimental program performed to examine the rate-dependent behavior of weld material in transverse welded lap joints at elevated temperatures under steady-state thermal conditions. The data are intended to support
Hantouche, Elie G. +3 more
core +1 more source
Advanced Materials Technologies, EarlyView.Parallel wiring of bioelectrochemical devices with conventional generators unexpectedly boosts output. A biophotovoltaic paired with a solar cell delivers up to 50% more power at low loads than their separate contributions; a plant microbial fuel cell shows similar current gains.
Valeria Marsaglia +4 more
wiley +1 more source
Shock and Vibration, 2013 This paper provides a critical overview of available technology and facilities for determining human-induced dynamic forces of civil engineering structures, such as due to walking, running, jumping and bouncing.
Vitomir Racic +2 more
doaj +1 more source
Measurements of 2-D flow parameters around rectangular prisms arranged at the ground
Budownictwo i Architektura, 2008 Measurements of 2-D flows around a square and a rectangle (ratio 2:1) in wind tunnel have been presented in this paper. The results of these measurements presented here are pressure and standard deviation distributions on the models’ walls, components of
Ewa Błazik-Borowa +4 more
doaj +1 more source
, 2017 Payá Zaforteza, IJ. (2017). SEI DIscussion Educating Engineers to Create Good-looking Bridges by Paul Gauvreau. Published in Structural Engineering International (SEI) vol. 26(3):198-206. Structural Engineering International. 27(1):134-135. doi:10.2749/
Paya-Zaforteza, Ignacio +1 more
core +1 more source
Advanced Materials Technologies, EarlyView.The study considers the use of polymer/dielectric‐based multilayers piezoelectric Energy Harvesters (EH) to produce an output voltage and current, by exploiting the mechanical energy provided by human organs movements. In particular, the heart motion is considered from the kinematic viewpoint, and a multiphysics theoretical model is developed to assess
Hamdi Ezzin +5 more
wiley +1 more source
Advances in Structural Control in Civil Engineering in China [PDF]
Mathematical Problems in Engineering, 2010 In the recent years, much attention has been paid to the research and development of structural control techniques with particular emphasis on alleviation of wind and seismic responses of buildings and bridges in China. Structural control in civil engineering has been developed from the concept into a workable technology and applied into practical ...
Li, Hongnan, Huo, Linsheng
openaire +2 more sources