Results 21 to 30 of about 3,169,862 (288)
Frontiers in Neuroscience, 2015 The purpose of this work was to demonstrate the feasibility of building recurrent artificial neural networks with hybrid complementary metal oxide semiconductor (CMOS)/memristor circuits.
Xinjie eGuo +8 more
doaj +1 more source
Journal of Low Power Electronics and Applications, 2023 Digital-based differential amplifiers (DDA) are particularly suitable to low voltage digital integrated circuit technologies. This paper presents an exhaustive analysis of digital-based analog amplifiers to take advantage of today’s high-performance ...
Anna Richelli +3 more
doaj +1 more source
Ultra-Low Voltage Analog IC Design: Challenges, Methods and Examples [PDF]
Radioengineering, 2018 The paper brings an overview of main challenges and design techniques effectively applicable for ultra-low voltage analog integrated circuits in nanoscale technologies.
V. Stopjakova +6 more
doaj
Sensors, 2021 To realize a large-scale Spiking Neural Network (SNN) on hardware for mobile applications, area and power optimized electronic circuit design is critical.
Malik Summair Asghar +2 more
doaj +1 more source
META HEURISTIC OPTIMIZATION APPROACH FOR CMOS BASED ANALOG CIRCUIT DESIGN AND PERFORMANCE EVALUATION OF EVOLUTIONARY ALGORITHMS [PDF]
ICTACT Journal on Soft Computing, 2023 Manual design of Complementary Metal Oxide Semiconductor (CMOS) based analog circuit design becomes more challenging and tedious task due to very complex physical models and variation in the fabrication process as technology scale down.
Sureshbhai L. Bharvad +2 more
doaj +1 more source
Design of Low-Power CMOS OTA Using Bulk-Drive Technique [PDF]
Journal of Intelligent Procedures in Electrical Technology, 2015 This paper presents the design of low power CMOS- OTA (operational transconductance amplifier) using bulk drive (BD) technique with broad band. This technique is used for design of low power circuits with broad band for high frequency users, for example ...
Maryam Ghadiri Modarres
doaj
EPJ Photovoltaics, 2022 The tracking of the maximum power point (MPP) of a photovoltaic (PV) solar panel is an important part of a PV generation chain. In order to track maximum power from the solar arrays, it is necessary to control the output impedance of the PV panel, so ...
Alahdal Abdulrahman +2 more
doaj +1 more source
From Sensing Mechanisms to System Co-Design: Graphene-Based Sensors and Readout Circuits. [PDF]
Adv Sci (Weinh)This review establishes a unified PS–EQ–RF framework linking graphene sensing mechanisms, native electrical outputs, and output‐specific readout circuits. Voltage‐, current‐, resistance‐, and capacitance‐type sensing systems are systematically classified to guide architecture selection, low‐noise design, system co‐design, and practical integration ...
Zhang J +5 more
europepmc +2 more sources
IEEE Access, 2020 In integrated circuit form, the front-end amplifier (FEA) determines the fidelity of the biosignal detection, signal-to-noise ratio, power consumption and detector size for the future multi-channel neural signal recording systems and applications ...
Zhijun Zhou
doaj +1 more source
Integrated Circuit Signal Generation and Detection Techniques for Microwave and Sub-Millimeter Wave Signals [PDF]
, 2012 The unabated reduction of device feature sizes in semiconductor processes, particularly in complementary metal-oxide semiconductor (CMOS) processes, has served as the enabling factor behind integrated electronic systems of ever increasing complexity and ...
Bohn, Florian
core +1 more source