Results 1 to 10 of about 2,592,786 (294)
0.3V Bulk-Driven Current Conveyor [PDF]
IEEE Access, 2019 This paper presents the design and the experimental results of a sub 0.5 V bulk-driven (BD) current conveyor (CCII) using 0.18 μm TSMC CMOS technology with a total chip area of 0.0134 mm2.
Fabian Khateb +2 more
doaj +4 more sources
Bulk-driven current conveyor optimization using simulation-based method [PDF]
E3S Web of Conferences, 2022 This paper presents the optimization of a novel low-voltage (LV) and low-power (LP) bulk driven current conveyor (CCII). For the bulk-driven circuits, the transistors are biased at the subthreshold regime for LV and LP operation.
Lberni Abdelaziz +3 more
doaj +2 more sources
A 1.9 nW, Sub-1 V, 542 pA/V Linear Bulk-Driven OTA with 154 dB CMRR for Bio-Sensing Applications
Journal of Low Power Electronics and Applications, 2021 In this paper, a new technique for improvement on the DC voltage gain, while keeping the high-linearity in symmetrical operational transconductance amplifier (OTA) bulk-driven (BD) topology is proposed.
Rafael Sanchotene Silva +3 more
doaj +3 more sources
0.5 V, Low-Power Bulk-Driven Current Differencing Transconductance Amplifier [PDF]
SensorsThis paper presents a novel low-power low-voltage current differencing transconductance amplifier (CDTA). To achieve a low-voltage low-power CDTA, the BD-MOST (bulk-driven MOS transistor) technique operating in a subthreshold region is used. The proposed
Montree Kumngern +2 more
doaj +2 more sources
Bulk-driven differential voltage follower
Electronics Letters, 2009 A new differential voltage follower based on bulk-driven transistors is presented. The constant differential gain with value close to unity, input common-mode suppression and rail-to-rail operation are the most important advantages of the proposed structure.
S. Vlassis, G. Raikos
exaly +2 more sources
±0.3V Bulk-Driven Fully Differential Buffer with High Figures of Merit
Journal of Low Power Electronics and Applications, 2022 A high performance bulk-driven rail-to-rail fully differential buffer operating from ±0.3V supplies in 180 nm CMOS technology is reported. It has a differential–difference input stage and common mode feedback circuits implemented with no-tail, high CMRR ...
Manaswini Gangineni +5 more
doaj +3 more sources
0.35 V Subthreshold Bulk-Driven CMOS Second-Generation Current Conveyor
Journal of Low Power Electronics and ApplicationsThis study describes a high-performance second-generation Current Conveyor (CCII) operating at 0.35 V and achieving rail-to-rail operation at the Y terminal and class AB current drive at the X and Z terminals.
Muhammad Omer Shah +2 more
doaj +3 more sources
EMI susceptibility in bulk-driven Miller opamp
Electronics Letters, 2010 A simple bulk-driven Miller amplifier is proposed. Along with the main operational amplifier (opamp) characteristics, the EMI susceptibility has also been investigated. The common nonlinearity problem of bulk-driven opamp architectures has been investigated and solved. The solution reduces also the EMI susceptibility.
Anna Richelli
exaly +3 more sources
Characterizing bulk-driven acoustic streaming in air
The Journal of the Acoustical Society of America, 2023 The time-independent fluid flows induced by the attenuation of acoustic energy known as acoustic streaming have been experimentally measured in air using particle image velocimetry for two high powered ultrasonic transducers. The literature declares that these bulk-driven “Eckart” streaming flows are observed as turbulent jets in the direction of the ...
Christopher Stone +3 more
openaire +2 more sources
31.3 nW, 0.5 V Bulk-Driven OTA for Biosignal Processing
IEEE Access, 2023 This paper presents a new extremely low-voltage low-power bulk-driven (BD) operational transconductance amplifier (OTA) realized for low frequency biosignal processing. The CMOS structure of the OTA utilizes bulk-driven and self-cascode techniques in the
Montree Kumngern +2 more
doaj +1 more source