A new bulk-driven input stage design for sub 1-volt CMOS op-amps [PDF]
, 2006 This paper presents a new design approach for a rail-to-rail bulk-driven input stage using a standard single-well (n-well in this paper) CMOS technology. This input stage can provide nearly constant transconductance and constant slew rate over the entire
Y. Haga +5 more
core +1 more source
CMOS buffer using complementary pair of bulk-driven super source followers [PDF]
, 2009 A power-efficient rail-to-rail CMOS analogue voltage buffer is presented. It consists of a complementary pair of super source followers, but a bulk-driven input device with the replica-biased scheme is utilised to eliminate the DC level shift, quasi ...
Haga, Y., Kale, I.
core +1 more source
Class-AB rail-to-rail CMOS buffer with bulk-driven super source followers [PDF]
, 2009 This paper describes a rail-to-rail CMOS analog voltage buffer designed to have extremely low static current consumption as well as high current drive capability.
Yasutaka Haga +3 more
core +1 more source
Thermomechanical Variational Principles for Dissipative Materials with Application to Strain Localization in Bulk Metallic Glasses [PDF]
, 2004 This thesis is concerned with variational principles for general coupled thermomechanical problems in dissipative materials including finite elastic and plastic deformation, non-Newtonian viscosity, rate sensitivity, arbitrary flow and hardening rule, as
Yang, Qiang
core +1 more source
Ultra-Low Voltage Analog IC Design: Challenges, Methods and Examples [PDF]
Radioengineering, 2018 The paper brings an overview of main challenges and design techniques effectively applicable for ultra-low voltage analog integrated circuits in nanoscale technologies.
V. Stopjakova +6 more
doaj
Analysis of BDMOS and DTMOS Current Mirrors in 130 nm CMOS Technology
Advances in Electrical and Electronic Engineering, 2018 In this paper, an analysis of basic Current Mirror (CM) topologies was performed with a focus on comparison of conventional realization to Bulk-Driven (BD) and Dynamic-Threshold (DT) equivalents, in terms of main properties.
Matej Rakus +2 more
doaj +1 more source
Kinetic Simulation of He radio frequency capacitively coupled plasma [PDF]
Delta Journal of Science, 2021 Radiofrequency capacitively coupled plasma is studied theoretically using a Particle-in-Cell code. For He discharge, the timeaveraged sheaths are in the range of few centimeters.
N. El-Siragy +3 more
doaj +1 more source
Mechanical performance and fracture behavior of Fe₄₁Co₇Cr₁₅Mo₁₄Y₂C₁₅B₆ bulk metallic glass [PDF]
, 2007 The mechanical properties of a new Fe₄₁Co₇Cr₁₅Mo₁₄Y₂C₁₅B₆ bulk glassy alloy were studied by impact bending, compression, and hardness tests carried out at room temperature.
Shen, Jun +3 more
core +1 more source
Bulk driven MOST transconductor with extended linearrange
Electronics Letters, 1996 The authors propose using the bulk terminal as an active terminal. This extends the linear range of MOST transconductors operating in weak inversion by a factor close to 2.
Fried, R., Enz, C. C.
openaire +2 more sources
Low-voltage bulk-driven flipped voltage follower-based transconductance amplifier [PDF]
, 2022 A low voltage high performance design of operational transconductance amplifier is proposed in this paper. The proposed architecture is based on bulk driven quasi-floating gate metal oxide semiconductor field effect transistor (MOSFET) which supports low
Nikhil Raj +7 more
core +2 more sources