Results 121 to 130 of about 23,817 (267)

A novel bubbling fluid bed reactor for the autothermal pyrolysis of waste plastics

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Abstract A new pilot‐scale fluidized bed reactor operated under continuous conditions was developed and tested for the thermal pyrolysis of high‐density polyethylene (HDPE). The study focused on assessing the reliability and operability of the system under different operating conditions (400–550°C), while monitoring mass and energy balances, product ...
Khadija Olivia Ogoula Igouwe   +4 more
wiley   +1 more source

Elevated urinary mutagenicity among those exposed to bituminous coal combustion emissions or diesel engine exhaust. [PDF]

open access: yesEnviron Mol Mutagen, 2021
Wong JYY   +27 more
europepmc   +1 more source

Experimental methods in chemical engineering: Temperature‐programmed oxidation—TPO

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Abstract Temperature‐programmed oxidation (TPO) probes the oxidative capacity and redox properties of solid materials—catalysts, metal oxides, perovskites, and carbonaceous deposits. It identifies coke type, distribution, and reactivity. TPO instruments pass an oxidizing gas (diluted O2$$ {\mathrm{O}}_2 $$, air, or less commonly N2O$$ {\mathrm{N}}_2 ...
Gholamreza Roohollahi   +7 more
wiley   +1 more source

The impact of coal combustion, nitrous oxide emissions, and traffic emissions on COVID-19 cases: a Markov-switching approach. [PDF]

open access: yesEnviron Sci Pollut Res Int, 2021
Anser MK   +5 more
europepmc   +1 more source

Harmonizing Social Impact Assessment in the Bioeconomy: A Cross‐Regional Fuzzy‐Delphi Approach

open access: yesCorporate Social Responsibility and Environmental Management, EarlyView.
ABSTRACT The bioeconomy transition risks underrepresenting social sustainability, while existing Social Life Cycle Assessment (S‐LCA) applications remain insufficient for comparison and decision support due to heterogeneous and non‐standardized selection of social impact categories. This study proposes a cross‐regional baseline set of impact categories
Julia Lessa Feitosa Virgolino   +2 more
wiley   +1 more source

Engineering the Lattice and Electronic Configurations of N‐Rich‐CoMoCN by Mo Doping and N Enrichment for Enhanced Water Splitting

open access: yesEcoEnergy, EarlyView.
This study design Mo‐doped and N‐rich‐CoMoCN bimetal for bi‐functionally efficient overall water splitting catalysts by constructing an active site and engineering the interfacial Co6Mo6C2/Co heterojunction in a N‐doped porous carbon matrix and study on the performance of catalyst for electrocatalytic.
Huimin Yang   +12 more
wiley   +1 more source

Lithium Metal Anode Fabrication: Methods, Challenges, and Strategies

open access: yesEcoEnergy, EarlyView.
Schematic illustration of four representative fabrication techniques for thin lithium metal anodes: extrusion, molten lithium infusion, electroplating, and physical vapor deposition (PVD). ABSTRACT The pursuit of ultra‐high energy‐dense lithium‐metal batteries (LMBs) has reignited the drive to fabricate ultrathin high‐quality lithium metal anodes. This
Ji Hyun Baek, Mi Ji Kang, Ho Won Jang
wiley   +1 more source

3‐Reactor Chemical Looping System for Point Source CO2 Capture and Subsequent Conversion for Liquid Fuel Production

open access: yesEcoEnergy, EarlyView.
This study presents a novel 3‐reactor chemical looping system for CO2 capture and subsequent utilization with biomass and natural gas for producing liquid fuels. Using Ca2Fe2O5\Fe2O3 oxygen carriers, it achieves 60% CO2 capture efficiency, ∼80% syngas purity, and autothermal operation, offering a scalable, carbon‐negative route to sustainable fuels ...
Krutarth Pandit   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy