Results 1 to 10 of about 251,961 (205)
Micro-Texture Analyses of a Cold-Work Tool Steel for Additive Manufacturing. [PDF]
Materials (Basel), 2020 Small objects of an alloy tool steel were built by selective laser melting at different scan speeds, and their microstructures were analyzed using electron backscatter diffraction (EBSD). To present an explicit correlation with the local thermal cycles in the objects, prior austenite grains were reconstructed using the EBSD mapping data.
Kang JY +7 more
europepmc +4 more sources
Effect of Deep Cryogenic Treatment on Wear Behavior of Cold Work Tool Steel
Metals, 2023 Shock resisting cold work tool steel is one of the most applicable steels for several applications such as cutting sheets, chisels, hammers, etc. It has been categorized according to its characteristic properties into different categories as hot and cold
Mahmoud A. Essam +4 more
doaj +3 more sources
Microstructural and Mechanical Characteristics of Novel 6% Cr Cold-Work Tool Steel
Metals, 2017 We investigated a new cold-work tool steel with a low Cr content of 6 wt. % which was designed based on thermodynamic calculation to minimize the formation of primary carbide.
Singon Kang, Minwook Kim, Seok-Jae Lee
doaj +3 more sources
Results in Materials, 2023 Shock resistance cold work tool steel (S5) has many applications such as blades for sheet cutting, manufacturing of chisel and hammers etc. This Steel has the ability to accommodate residual stresses without premature failure.
Mahmoud A. Essam +4 more
doaj +3 more sources
Microstructural and Mechanical Evaluation of a Cr-Mo-V Cold-Work Tool Steel Produced via Electron Beam Melting (EBM). [PDF]
Materials (Basel), 2021 Botero CA +7 more
europepmc +2 more sources
SYNERGY BY MOLYBDENUM AND NIOBIUM ON PERFORMANCE OF COLD WORK TOOL STEELS
Journal of Sustainable Technologies and MaterialsFor the die industry, where future products have a decisive role in material selection, the subject of steel is an area of interest with high innovation potential.
Aslan Unal
doaj +2 more sources
THE POSSIBILITIES OF THE RETAINED AUSTENITE REDUCTION ON TOOL STEELS [PDF]
European Journal of Materials Science and Engineering, 2021 The retained austenite induces a great deal of internal stress in the steel, often manifesting itself as cracks. Retained austenite also have a negative effect on dimensional stability of the steel components.
László TÓTH
doaj +1 more source
Study of Short Times Tempering for AISI D2 Cold Work Tool Steel
Materials Research, 2023 Short time tempering has been applied to steels to improve toughness keeping the hardness at the same level. For AISI D2 tool steel, typical thermal cycles are quench and temper.
Maycoln D. Conci +3 more
doaj +1 more source
Development of a New PM Tool Steel for Optimization of Cold Working of Advanced High-Strength Steels
Metals, 2020 In the present study, Uddeholm Vancron SuperClean cold work tool steel was investigated concerning wear resistance and fatigue strength, using laboratory and semi-industrial tests.
Abdulbaset Mussa +3 more
doaj +1 more source
Die Material Selection Criteria for Aluminum Hot Stamping
Journal of Manufacturing and Materials Processing, 2021 The aim of this work is to develop a die material selection criterion for aluminum hot stamping applications. The criterion has been based on the back-to-back comparison of a set of reciprocating friction and wear tests.
Maider Muro +2 more
doaj +1 more source