Development and parametric evaluation of the prototype 2 and 3 flash evaporators [PDF]
Development of the Prototype 2 and 3 flash evaporator heat sinks which vaporize an expendable fluid to cool a heat transport fluid loop is reported. The units utilize Freon 21 as the heat transport fluid and water as the expendable fluid to meet the ...
Dietz, J. B., Hixon, C. W.
core +1 more source
The Fabrication of Porous Metal-Bonded Diamond Coatings Based on Low-Pressure Cold Spraying and Ni-Al Diffusion-Reaction. [PDF]
Materials (Basel), 2022 Zhang Z +6 more
europepmc +1 more source
Microstructure and characteristics of nickel coatings deposited on titanium alloy by cold spraying
Авіаційно-космічна техніка та технологіяThe subject of this research is the dependence of the influence of cold spraying regimes on coating characteristics. This paper aims to approve the recommended cold-spraying regimes, which operate at an air pressure of up to 1.0 MPa, and to determine the
Oleksandr Shorinov +3 more
doaj +1 more source
Cold-spray technique as efficient alternative process for consolidation of powdered Al-Fe-Cr alloys reinforced by nanoquasicrystalline particles [PDF]
, 2011 A brief outline of the processing parameters involved in the search for technique offering efficient consolidation of high-temperature strength Al-based powdered alloys reinforced by metastable nanoquasicrystalline particles is presented.
Byakova, A.V. +3 more
core
Cold Spray: Over 30 Years of Development Toward a Hot Future [PDF]
, 2022 Deliang Guo +14 more
openalex +1 more source
Spartan Daily, August 31, 1981 [PDF]
, 1981 Volume 77, Issue 2https://scholarworks.sjsu.edu/spartandaily/6777/thumbnail ...
San Jose State University, School of Journalism and Mass Communications
core +1 more source
, 2015 Unencapsulated aluminum wedge wire bonds are common in particle physics pixel and strip detectors. Industry-favored bulk encapsulation is eschewed due to the range of operating temperatures and radiation.
Boyd, Rusty +2 more
core +1 more source
Science and Technology of Advanced Materials, 2008 In recent years, coating processes based on the impact of high-velocity solid particles such as cold spraying and aerosol deposition have been developed and attracting much industrial attention.
Seiji Kuroda et al
doaj
Mechanical Alloying Integrated with Cold Spray Coating for Fabrication Cu50(Ti50−xNix), x; 10, 20, 30, and 40 at.% Antibiofilm Metallic Glass Coated/SUS304 Sheets [PDF]
, 2022 Ahmad Aldhameer +4 more
openalex +1 more source
Bonded solid lubricant coating Patent [PDF]
, 1964 Bonded solid lubricant coatings of calcium fluoride and binder for high temperature ...
Sliney, H. E.
core +1 more source