Results 81 to 90 of about 17,379 (304)
Metallization of Various Polymers by Cold Spray [PDF]
Journal of Thermal Spray Technology, 2017 Previous results have shown that metallic coatings can be successfully cold sprayed onto polymeric substrates. This paper studies the cold sprayability of various metal powders on different polymeric substrates. Five different substrates were used, including carbon fiber reinforced polymer (CFRP), acrylonitrile butadiene styrene (ABS), polyether ether ...
Che, Hanqing +3 more
openaire +2 more sources
Materials Research Express, 2023 The paper considers the conducted study of the complex effect of low-pressure cold spraying parameters, namely the nozzle inlet temperature, stand-off distance, and powder feed rate on the adhesion and deposition efficiency of coatings from a Ni+Al _2 O ...
Oleksandr Shorinov +3 more
doaj +1 more source
Optimization of Technological Parameters for Cold Spraying Using the Response Surface Method
Cold spray technology can obtain coatings in a solid state, which is suitable for deposition protective and restorative coatings. Currently, most of the research in cold spraying is based on a single-factor analysis to explore the law.
Oleksandr Shorinov, Wenjie Hu
core +1 more source
Numerical Investigation on Particle Velocity in Cold Spraying of Hydroxyapatite Coating
, 2011 Hydroxyapatite (HA) is a calcium phosphate ceramics and HA coating is essential for the medical metallic implants. This paper presents a novel cold spraying method for the formation of HA coatings instead of the commonly used thermal spraying method. The
Wen Tao Zhang, Lei Zhang
core +1 more source
Advanced Materials, EarlyView.Inspired by viral entry mechanisms, the FUSION assay enables autonomous detection of respiratory viruses via membrane fusion–triggered CRISPR‐Cas13a activation. VEACON selectively fuses with fusion‐competent viruses, triggering fluorescence within confined vesicles.
Jae Chul Park +15 more
wiley +1 more source
Numerical simulation on deposition phenomena of impact particle in cold spraying process [PDF]
, 2013 Cold spraying is a new coating technique that makes a thin layer on the solid surface of various mechanical components using tiny material particles.
Yamamoto, M., Okano, H.
core +1 more source
Wear and Corrosion Properties of Cold Sprayed 420 Stainless Steel/WC-17Co Coating on Magnesium Alloy
Journal of Aeronautical Materials, 2018 420/WC-17Co coating was deposited on AZ80 magnesium alloy substrate by cold spraying technology. SEM was used to characterize the original powder morphology and coating microstructure.
CHEN Jie +5 more
doaj +1 more source
Investigation of Flow Parameters for Titanium Cold Spraying using CFD Simulation
, 2010 A comprehensive study of cold gas dynamic spray technology is required for optimising performance and gun design for spraying various materials. Cold spraying technology is a new technique in industry and very limited data is available.
Singh, Tejinder
core
Advanced Materials, EarlyView.Elephant‐skin‐inspired crack networks are programmed in porous diatomaceous earth (DE)‐cement composites using substrate‐guided, stress‐concentration induced fracture. The resulting crack lattices act as capillary conduits that redistribute water, while the porous matrix stores moisture.
Qingya Huang +5 more
wiley +1 more source
SURFACE REPAIR OF AIRCRAFT TITANIUM ALLOY PARTS BY COLD SPRAYING TECHNOLOGY
Авіаційно-космічна техніка та технологія, 2020 Titanium alloys have the advantages of high specific strength, good corrosion resistance, high heat resistance, and low density, which is the main structural material of aerospace system components, including compressor blade, cartridge receiver, blisk ...
Wenjie Hu +4 more
doaj +1 more source