Results 11 to 20 of about 70,126 (153)
Extracting the Cole-Cole impedance model parameters without direct impedance measurement
Electronics Letters, 2010 A filter-based technique to extract the four parameters that characterise a single-dispersion Cole-Cole impedance model without direct measurement of the impedance real and imaginary parts is reported. Experimental results in the range 100 Hz-5 MHz using apples, apricots and kiwi fruits are given and results are compared with numerical simulations of ...
A.S. Elwakil, B. Maundy
openaire +3 more sources
Journal of Advanced Research, 2020 The purpose of this study is to identify if participation in an eccentric exercise protocol altered the Cole-impedance model parameters that represent localized bicep tissue bioimpedance.
Bo Fu, Todd J. Freeborn
doaj +3 more sources
Cole–Cole, linear and multivariate modeling of capacitance data for on-line monitoring of biomass [PDF]
Bioprocess and Biosystems Engineering, 2008 This work evaluates three techniques of calibrating capacitance (dielectric) spectrometers used for on-line monitoring of biomass: modeling of cell properties using the theoretical Cole-Cole equation, linear regression of dual-frequency capacitance measurements on biomass concentration, and multivariate (PLS) modeling of scanning dielectric spectra ...
Dabros, Michal +6 more
openaire +5 more sources
Evaluation of SAR and Temperature Rise in Human Hand Due to Contact Current From 100 kHz to 100 MHz
IEEE Access, 2020 International guidelines/standards for the protection of humans from radiofrequency exposure have set a limit by assuming the lowest threshold for a classical heating effect, among other effects.
Taiki Murakawa +9 more
doaj +1 more source
IEEE Access, 2021 Recently, a growing research on the electromagnetic properties of biological tissues has been observed, particularly at microwave frequencies. The frequency variation of the dielectric properties of tissues at microwave frequencies may be described by ...
Tarek M. Said +2 more
doaj +1 more source
Sensors, 2022 Airborne transient electromagnetic (ATEM) technology is a technique often used in mineral exploration and geological mapping. Due to inductive polarization (IP) phenomena, the ATEM response curve often shows a negative response or declines rapidly to the
Da Lei +4 more
doaj +1 more source
On the role of the J-E constitutive relationship in applied geoelectromagnetism
Annals of Geophysics, 2003 In current applications of the Induced Polarization (IP) method, the Debye and Cole-Cole models are used to study relaxation and dispersion properties of rocks, though it is believed that this type of modelisation is confused and vague, because
D. Patella
doaj +1 more source
Zhongguo dianli, 2020 Silicone gel materials are used as packaging material for IGBT devices. Under the operating conditions, the devices are subjected to a repetitive on-off voltage which corresponds to the wide spectrum, and the device loss will cause temperature rise.
Yuan MAO +4 more
doaj +1 more source
International Journal of Electrochemical Science, 2019 Using the Randles circuit model, we determined that, for the impedance to fall on a straight line in a Cole-Cole plot, a dimensionless fluctuation coefficient that represents the quantity of the fluctuation in ion concentration near an electrode must be ...
M. Saitou
doaj +1 more source
Time-domain solution of Cole-Cole model with induced polarization method
IOP Conference Series: Earth and Environmental Science, 2020 Abstract The spectral parameters of the Cole-Cole model can be used to distinguish the IP anomalies of different geological bodies. However, the frequency domain IP requires a lot of observation data and its efficiency in field work is low. In view of this reality which is very common to use the data of the time-domain IP.
Ruize Liu, Qingxin Meng
openaire +1 more source