Results 61 to 70 of about 2,636,943 (227)

A lumped kinetic model for heavy fuel oil combustion

open access: yes, 2015
The study proposes a new procedure based on the Coats-Redfern method to develop kinetic model for predicting the combustion characteristics of heavy fuel oils.
Han, Yunqing   +3 more
core  

Nanoporous Silica Embedded in Nanoporous Platinum: A Versatile Composite Coating for Implant‐Associated Drug Delivery From Neuronal Electrodes

open access: yesAdvanced Materials Technologies, EarlyView.
Nanoporous silica nanoparticles incorporated in nanoporous platinum offer the possibility for implant‐associated drug delivery from neuronal electrodes. ABSTRACT Sensorineural hearing loss, resulting from damage to the hair cells of the inner ear, profoundly impairs quality of life.
Mosaieb Habib   +10 more
wiley   +1 more source

Investigation on A.T.A.C. Combustion in Two-Stroke gasoline Engine

open access: yes, 1995
The paper deals with experimentai activity concerning an unconvenhional combustion system, called A.T.A.C., far two-stroke, gasoline engines. A.T.A.C. primes fresh gas combustion by means of residual gas energy and improves combustion stability at light
TOGNOTTI, LEONARDO   +4 more
core   +1 more source

Additively Manufactured Porous Ceramics as Tunable Dielectrics for Passive Temperature Sensing

open access: yesAdvanced Materials Technologies, EarlyView.
Porous ceramic lattices, 3D‐printed from a multicomponent oxide ink, are integrated with LC resonators for passive wireless temperature sensing. By tuning porosity, the dielectric properties and RF response are engineered to produce distinct resonant frequency shifts with temperature. The results establish a structure‐driven approach to customizing the
Sogol Heidarishahrivar   +5 more
wiley   +1 more source

Mitigating furnace pressure fluctuations under rapid load ramping using a wavelet-LSTM-PPO based intelligent control framework

open access: yesFrontiers in Energy Research
Rapid load ramping in coal-fired power plants with high renewable energy integration often induces severe furnace pressure fluctuations, threatening combustion stability and operational safety.
Zhibin Jing   +5 more
doaj   +1 more source

Influence of intake oxygen enrichment ratio on combustion and emission performance of ammonia-hydrogen internal combustion engine [PDF]

open access: yesJournal of Hebei University of Science and Technology
In response to the problems of slow combustion speed, difficult ignition and high emissions of ammonia-hydrogen fuel in internal combustion engines, the combustion speed and stability of the ammonia-hydrogen mixture were improved by increasing the intake
Yue XU   +4 more
doaj   +1 more source

Combustion of methanol in diesel engine using diethyl ether as ignition enhancer

open access: yes, 2017
In this study, combustion of methanol in diesel engine is investigated using diethyl ether (DEE) as an ignition enhancer. Both experimental and numerical studies were performed and the results are compared with baseline diesel fuel.
Vallinayagam, R.   +5 more
core  

Defect‐Engineered ZnO Nanowire Arrays for Flexible Room‐Temperature Hydrogen Sensors

open access: yesAdvanced Materials Technologies, EarlyView.
Fabrication process of patterned ZnO nucleation sites on a flexible polyimide (PI) substrate. Top/tilted‐view SEM images of ordered ZnO nanoflower arrays confined within patterned circular regions. AFM topography map with height data revealing a disk‐array structure, where the patterned regions (marked by a red dot circle) are elevated by ∼2 µm ...
Jun‐Ting Wang   +7 more
wiley   +1 more source

Annular Air Gap Area Impact on Flame Regime Transition and Combustion in Low-chamber-pressure Air Heater [PDF]

open access: yesJournal of Applied Fluid Mechanics
This study combines high-speed shadowgraph imaging with numerical simulations to systematically examine the effect of the annular air gap area on the spray combustion characteristics of an alcohol-liquid-oxygen-air tripropellant coaxial direct-flow ...
K. Wang, C. B. Shen, B Fan
doaj   +1 more source

Microfabrication of Soft Millirobots Propelled by Low Voltage Electrohydraulic Actuators

open access: yesAdvanced Materials Technologies, EarlyView.
Manual layer‐by‐layer assembly is replaced by wafer‐level MEMS batch fabrication for compliant polymer‐based electrohydraulic actuators. The microfabricated devices integrate sacrificially defined microcavities, Parylene‐C‐sealed inlets, and multilayer polymer–metal films.
Shai Shmulevich   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy