Results 221 to 230 of about 482,540 (308)
Some of the next articles are maybe not open access.

A Common-Mode Voltage Elimination Method With Active Neutral Point Voltage Balancing Control for Three-Level T-Type Inverter

IEEE transactions on industry applications, 2022
Nowadays, the three-level T-type inverters (3LT2Is) are widely employed in applications with high-performance requirements. The 3LT2Is commonly suffer from neutral point voltage (NPV) unbalance and common-mode voltage (CMV) variation.
M. Lak, Bing-Rong Chuang, Tzung-Lin Lee
semanticscholar   +1 more source

Zero-Sequence Current Suppression Strategy With Common-Mode Voltage Control for Open-End Winding PMSM Drives With Common DC Bus

IEEE transactions on industrial electronics (1982. Print), 2021
The zero-sequence loop inherently exists in the structure of the three-phase open-end winding permanent-magnet synchronous machine (OW-PMSM) system with common dc bus, which provides the circulating path for zero-sequence current (ZSC) and consequently ...
Wei Hu, Chenhui Ruan, H. Nian, Dan Sun
semanticscholar   +1 more source

A Virtual Space Vector PWM With Active Neutral Point Voltage Control and Common Mode Voltage Suppression for Three-Level NPC Converters

IEEE transactions on industrial electronics (1982. Print), 2021
Virtual space vector pulsewidth modulation (VSVPWM) provides a new approach to neutral point voltage (NPV) control and common mode voltage (CMV) suppression. Few values of coefficients configured in the virtual vectors cannot adjust the NPV continuously.
Shuai Xia   +4 more
semanticscholar   +1 more source

Novel Voltage-Balance Control of Four-Level Hybrid-Clamped Converter With Open-Loop Optimized Common-Mode Voltage Injection

IEEE transactions on power electronics, 2022
The four-level hybrid-clamped converter (HCC) is a new high-efficiency dc–ac converter. However, its dc-link capacitors face challenging voltage fluctuation issues at low frequencies, resulting in the distorted ac current and oversize converter volume ...
Yihui Zhao   +5 more
semanticscholar   +1 more source

Space Vector PWM Based DTC Scheme With Reduced Common Mode Voltage for Five-Phase Induction Motor Drive

IEEE transactions on power electronics, 2021
In multiphase induction motor drives, lowering the common-mode voltage (CMV) reduces motor insulation degradation and the existence of destructive bearing current. For this investigation, a five-phase two-level voltage source inverter (FPTL-VSI) fed five-
Utkal Ranjan Muduli   +2 more
semanticscholar   +1 more source

Supervised Learning Model Predictive Control Trained by ABC Algorithm for Common-Mode Voltage Suppression in NPC Inverter

IEEE Journal of Emerging and Selected Topics in Power Electronics, 2021
Training the weighting factors of model predictive control in multiobjective problems is a time consuming and sophisticated process. In this article, conventional model predictive control (CMPC) has been developed as supervised learning model predictive ...
M. Babaie   +4 more
semanticscholar   +1 more source

Study of Common-Mode Voltage Measurements for IEC62684

IEEE Transactions on Industry Applications, 2013
This paper presents the study of common-mode (CM) voltage measurements for IEC62684 regulatory. Due to the digitization error caused by the limited vertical bit number of the analog-to-digital converter (ADC) in oscilloscopes, the CM voltage spectrum measurement of the flyback converter with AC source occurs significant inaccuracy.
Ray-Lee Lin   +2 more
openaire   +1 more source

A Soft-Switching Current-Source-Inverter-Fed Motor Drive With Reduced Common-Mode Voltage

IEEE transactions on industrial electronics (1982. Print), 2021
This article proposes a common-mode voltage (CMV) attenuation method for the three-phase current source inverter (CSI)-fed permanent-magnet synchronous machine drive.
Yang Xu   +3 more
semanticscholar   +1 more source

Active Common-Mode Voltage-Based Open-Switch Fault Diagnosis of Inverters in IM-Drive Systems

IEEE transactions on industrial electronics (1982. Print), 2021
Fast and reliable fault diagnosis is essential for induction motor (IM) drive systems with high-reliability requirements. In this article, we propose a robust open-switch fault-diagnosis method based on the common-mode voltages of the inverter in the IM ...
Yitao Cheng   +5 more
semanticscholar   +1 more source

A Fast-Processing Predictive Control Strategy for Common-Mode Voltage Reduction in Parallel Three-Level Inverters

IEEE Journal of Emerging and Selected Topics in Power Electronics, 2021
Model predictive control (MPC) is an attractive control scheme, in particular, for multilevel converters. However, MPC suffers from high computational burden and tedious tuning of weighting factors especially for parallel three-level inverters. Moreover,
Xiangyang Xing, Hua Chen
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy