Results 251 to 260 of about 29,585 (278)
Some of the next articles are maybe not open access.
Epoxy composites for insulating properties
2015 IEEE Electrical Insulation Conference (EIC), 2015Among materials used for electrical insulation in power electronics systems like IGBT, silicone elastomers used are considered as good candidates but are limited to 180–200°C. In this work, new thermoset/thermoplastic composites are investigated. The addition of some thermoplastics to epoxy amine systems can lead to system exhibiting phase separation ...
N. Halawani +3 more
openaire +1 more source
2013
Composite long rod insulators are primarily used in suspension strings in straight-line supports and as tension strings in anchor towers and dead-end towers. They are also used in the jumpers or portals of outdoor substations. In some cases, composite long rods are used in the guys of wooden poles, and more rarely in the guys of steel towers.
Konstantin Papailiou, Frank Schmuck
openaire +1 more source
Composite long rod insulators are primarily used in suspension strings in straight-line supports and as tension strings in anchor towers and dead-end towers. They are also used in the jumpers or portals of outdoor substations. In some cases, composite long rods are used in the guys of wooden poles, and more rarely in the guys of steel towers.
Konstantin Papailiou, Frank Schmuck
openaire +1 more source
The breakdown of composite insulation
Conference on Electrical Insulation & Dielectric Phenomena - Annual Report 1972, 1972It is frequently assumed that composite insulation, consisting for example, of a column of air in series with a solid dielectric, breaks down because a discharge in the weaker gaseous section acts like a thin conducting extension of the electrode.
R. Cooper, D. W. Auckland
openaire +1 more source
Performance Analysis of Composite Insulators
2019 IEEE 3rd International Electrical and Energy Conference (CIEEC), 2019Composite insulators are widely used in high voltage transmission lines in coast and polluted areas due to excellent pollution flashover resistance, high strength and convenient installation and maintenance. While there are still various kinds of defects such as abnormal temperature rise, aging of materials even fracture in the existing composite ...
Tingting Wang +5 more
openaire +1 more source
High Pollution Resistant Composite Insulators
2008 International Conference on High Voltage Engineering and Application, 2008Composite insulators with silicone rubber housing have been applied since more than 40 years successfully under various climatic and pollution stress conditions. Since the service experience was not available in the introduction phase (Generation I and II) of this insulator technology in the early 1970ies, the life-expectation for composite insulators ...
J. M. Seifert, D. Stefanini
openaire +1 more source
Sound insulation of composite materials
Composites, 1974Abstract The relationships between a material's physical properties and its sound insulation are discussed. The sound insulation of composite materials can be estimated provided that these physical properties are known. Although composites may be designed to give a better than average sound insulation performance for their mass, the sound insulation ...
openaire +1 more source
Nacre-Inspired Hybrid Multilayer Insulation Composites
ACS Applied Materials & InterfacesSuperinsulation aerogels are characterized by low tensile strength and brittleness due to their high porosity. To address these limitations, multiscale architectural design inspired by nacre can be employed. This materials design approach offers a promising strategy for enhancing the mechanical strength of aerogel thermal insulation.
Long Zhu +5 more
openaire +2 more sources
Metal/insulator composite selective absorbers
Solar Energy Materials, 1979Abstract The optical properties of metal/insulator composite films have been examined, and their utilization as solar selective absorbers studied both theoretically and experimentally. Calculations have been made on the solar selective performance of graded composite films, demonstrating the performance and limitations to be expected for the general ...
H.G. Craighead +4 more
openaire +1 more source
Insulation Hysteresis in Micaceous Composites
IEEE Transactions on Electrical Insulation, 1982The dissipation factor, sensitive to voltage stress, is invariably used for quality assessment of high voltage rotating machine insulation. When it is subjected to higher electrical stresses, insulation hysteresis occurs during these measurements, which is similar to those exhibited by ferromagnetic materials. The influence of the insulation hysteresis
openaire +1 more source
Natural, Rotationally Asymmetric Ageing of Composite Insulators
Conference Record of the 2008 IEEE International Symposium on Electrical Insulation, 2008The market for polymeric insulators has existed for over 20 years and the possibility now exists to compare good quality service-aged products with the original expectations of performance. This paper presents investigations of field-aged insulators, which have been deployed for 6-7 years on a variety of distribution lines.
Da Silva, E., Rowland, S. M.
openaire +2 more sources