Variable cavity volume tooling for high-performance resin infusion moulding [PDF]
, 2010 This article describes the research carried out by Warwick under the BAE Systems/EPSRC programme ‘Flapless Aerial Vehicles Integrated Interdisciplinary Research – FLAVIIR’.
Hansell, Robert George +2 more
core +1 more source
Timing for Composite Resin Placement on Mineral Trioxide Aggregate [PDF]
, 2013 Introduction The aim of this study was to investigate the proper time to restore composite resin over mineral trioxide aggregate (MTA). Methods Thirty-five samples of MTA blocks were divided into 7 groups with 3 different times (10 minutes, 1 day, and 7 ...
Tsujimoto, Yasuhisa +6 more
core +1 more source
Coupled visco-mechanical and diffusion void growth modelling during composite curing [PDF]
, 2010 Most critical processing step during long fiber reinforced epoxy matrix composite laminate manufacturing is the polymerization stage. If not optimized, it gives birth to defects in the bulk material, such as voids.
Bernhart, Gérard +10 more
core +1 more source
Compressive Strength of Bulk-Fill and Conventional Nano-hybrid Composite Resins: An in Vitro Study
Journal of Dental School, 2021 Objectives Evaluation of the properties of recently introduced bulk-fill composite resins from different aspects is important. We aimed to evaluate the compressive strength of two bulk-fill composite resins with different viscosities compared with one ...
Maryam Mofidi +3 more
doaj +1 more source
FABRICATION AND CHARACTERIZATION OF THE COMPOSITES OF RESIN - HUSK OF RICE AND RESIN - RUB ASH
Spektra: Jurnal Fisika dan Aplikasinya, 2018 We have done the fabrication of two kinds of composite material the fillers that we used rub ash for one type of composite and the husk of rice for another, the matrix for both is resin.
Muhammad Lawrence Pattersons +4 more
doaj +1 more source
MATEC Web of Conferences, 2017 In the present investigation, we used two types of thermoset resins (epoxy resin and phenol formaldehyde resin) with carbon fiber (CF) to produce composite materials.
Fouda Hany, Guo Lin, Elsharkawy Karim
doaj +1 more source
Self-adhesive flowable resin composite for occluso-proximal restorations in primary teeth: restorative time and fracture resistance analysis [PDF]
Journal of Applied Oral ScienceRestoring occluso-proximal cavities in primary molars is clinically challenging due to their anatomical characteristics and the difficulty of matrix adaptation.
Tyler Zanella Brustolin +4 more
doaj +2 more sources
Padjadjaran Journal of Dentistry, 2020 Introduction: The adhesive system strongly influences the bond strength of resin composite to the tooth surface. Aside from the commonly used etch and rinse, and self-etch adhesive system and a new approach called self-adherent composite resin to combine
Myrna Nurlatifah Zakaria +4 more
doaj +1 more source
Temperature rise beneath a light–cured materials using two types of curing machines [PDF]
Al-Rafidain Dental Journal, 2006 Aim: To measure the temperature rise induced by a light emitting diode (LED) curing unit and by quartz tungsten halogen (QTH) curing unit using two types of composite resin XRV Herculite and Venus.
Sabah A Ismail, Abdul–Haq A Suliman
doaj +1 more source
A dielectric sensor for measuring flow in resin transfer moulding. [PDF]
, 2000 The development, analysis and experimental validation of a novel flow and cure sensor for use in the resin transfer moulding of composites are presented.
Karkanas, Panagiotis I. +2 more
core +1 more source