Results 111 to 120 of about 187,054 (294)
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Journal of Rock Mechanics and Geotechnical EngineeringPolyurethane foam, when used as a compressible layer in deep soft rock tunnels, offers a feasible solution to reduce the support pressure on the secondary lining.
Haibo Wang +5 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study examines how several molten high‐silicon electrical steels interact with both conventional and recycled MgO–C refractories. For this, various immersion experiments are conducted. In addition to infiltration, a number of mechanisms are identified and explained that control the corrosion of the refractory material.
Lukas Neubert +7 more
wiley +1 more source
Archives of Mechanics, 2015 This paper studies the propagation of Rayleigh waves in an orthotropic elastic half-space coated by a thin orthotropic elastic layer. The half-space and the layer are assumed to be either compressible or incompressible and they are in sliding contact ...
P.C. Vinh, V.T.N. Anh
doaj +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Scientific ReportsThe impact of different turbulence on beams can be seen as optical distortions caused by refractive index fluctuations around vortices in turbulence. Therefore, from the perspective of transmission effects, the transmission outcomes of beam in different ...
Wenjie Wu, Jinyu Xie, Lu Bai
doaj +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Thickness variation parameter in a thin rotating disc by finite deformation [PDF]
FME Transactions, 2013 Seth’s transition theory is applied to the problems of thickness variation parameter in a thin rotating disc by finite deformation. Neither the yield criterion nor the associated flow rule is assumed here.
Pankaj Thakur, Singh S.B., Jatinder Kaur
doaj
Calculation methods for compressible turbulent boundary layers, 1976 [PDF]
Equations and closure methods for compressible turbulent boundary layers are discussed. Flow phenomena peculiar to calculation of these boundary layers were considered, along with calculations of three dimensional compressible turbulent boundary layers ...
Bushnell, D. M. +2 more
core +1 more source