Results 31 to 40 of about 3,903,556 (353)
Materials Research Express, 2021 Micrometer scale zirconia toughened alumina particles (ZTA _p ) reinforced high chromium cast iron (HCCI) matrix composites were prepared by the non-pressure infiltration casting process, which solved the poor compounding of micrometer scale ceramic ...
Hongbin Zeng +5 more
doaj +1 more source
Study on the Compressive and Tensile Properties of Gneiss Outcrop of Bozhong 196 Gas Field in China
Energies, 2023 In this paper, based on the gneiss outcrop of Bozhong 196 gas field in China, uniaxial compression and Brazil splitting tests were conducted by using cores of different orientations.
Lianzhi Yang +3 more
doaj +1 more source
Plastic mechanisms for thin-walled cold-formed steel members in eccentric compression. [PDF]
, 2015 The Eurocode 3 concerning thin-walled steel members divides members subjected to compression into four classes, considering their ductility. The representatives of the class C4 are short bars, for which the load-capacity corresponds to the maximum ...
Grudziecki, J. +2 more
core +2 more sources
Size-dependent mechanical properties of molybdenum nanopillars [PDF]
, 2008 We report the deformation behavior of single crystalline molybdenum nanopillars in uniaxial compression, which exhibits a strong size effect called the “smaller is stronger” phenomenon.
Greer, Julia R., Kim, Ju-Young
core +1 more source
, 2011 To measure the magnetic field strength in the solar corona, we examined 10 fast (> 1000 km/s) limb CMEs which show clear shock structures in SOHO/LASCO images.
Bemporad +28 more
core +1 more source
Failure analysis of CFRP laminates subjected to Compression After Impact: FE simulation using discrete interface elements [PDF]
, 2013 This paper presents a model for the numerical simulation of impact damage, permanent indentation and compression after impact (CAI) in CFRP laminates.
Bouvet, Christophe +2 more
core +3 more sources
ACS Biomaterials Science & Engineering, 2017 This article demonstrates a two-step method to 3D print double network hydrogels at room temperature with a low-cost ($300) 3D printer. A first network precursor solution was made 3D printable via extrusion from a nozzle by adding a layered silicate to ...
Feichen Yang +2 more
semanticscholar +1 more source
Numerical and Experimental Study on End Effect of Waste-Soil Samples under Uniaxial Compression
Geofluids, 2022 In order to investigate the influence of end effect on the waste-soil sample strength under uniaxial compression, the influence law of end effect on the uniaxial compression strength is numerically simulated by the FLAC3D software, and the reliability of
Yukai Wang, Xiaoli Liu, Bo Pang
doaj +1 more source
General Treatment of Vortical, Toroidal, and Compression Modes
, 2011 The multipole vortical, toroidal, and compression modes are analyzed. Following the vorticity concept of Ravenhall and Wambach, the vortical operator is derived and related in a simple way to the toroidal and compression operators. The strength functions
Kleinig, W. +4 more
core +1 more source
The compressive strength of crumpled matter [PDF]
Nature Communications, 2019 AbstractCrumpling a sheet creates a unique, stiff and lightweight structure. Use of crumples in engineering design is limited because there are not simple, physically motivated structure-property relations available for crumpled materials; one cannot trust a crumple. On the contrary, we demonstrate that an empirical model reliably predicts the reaction
Andrew B. Croll +2 more
openaire +3 more sources