Results 41 to 50 of about 90,574 (337)
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Energies, 2019 A new methodology for predicting the real instantaneous in-cylinder volume in the combustion chamber of a reciprocating internal combustion engine is implemented.
Franklin Consuegra +4 more
doaj +1 more source
Jet Ignition Research for Clean Efficient Combustion Engines [PDF]
, 2013 poster abstractIgnition by a jet of hot gas has application in lean-burn pre-chamber internal combustion engines and in innovative pressure-gain combustors for gas turbine engines.
Chinnathambi, Prasanna +3 more
core
Advanced Engineering Materials, EarlyView.A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain +7 more
wiley +1 more source
Thermodynamic Cycle Analysis for Wave Rotor Combustor Based Combined Cycle [PDF]
, 2013 poster abstractThe conventional combustor that exists in today’s market is a constant pressure device; whereas, the wave rotor combustor investigated in the present research is a constant volume pressure gain device.
Collins, Jessica +3 more
core
Advanced Engineering Materials, EarlyView.Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source
Journal of Traffic and Transportation Engineering (English ed. Online)In this work, 20% of polymethoxy dimethyl ether (PODE) and n-butanol are blended with F-T diesel by volume, respectively, referred to as FP20 and FBU20.
Limin Geng +6 more
doaj +1 more source
, 2018 Acoustic dampers are efficient and cost-effective means for suppressing thermoacoustic instabilities in combustion chambers. However, their design and the choice of their purging air mass flow is a challenging task, when one aims at ensuring ...
Bourquard, Claire, Noiray, Nicolas
core +1 more source
Radiative heat transfer during turbulent combustion [PDF]
, 2009 We investigate the radiative heat transfer in a co-flowing turbulent nonpremixed propane-air flame inside a three-dimensional cylindrical combustion chamber.
Paul, M.C., Paul, S.C.
core +1 more source
Laser‐Induced Graphene from Waste Almond Shells
Advanced Functional Materials, EarlyView.Almond shells, an abundant agricultural by‐product, are repurposed to create a fully bioderived almond shell/chitosan composite (ASC) degradable in soil. ASC is converted into laser‐induced graphene (LIG) by laser scribing and proposed as a substrate for transient electronics.
Yulia Steksova +9 more
wiley +1 more source