Results 81 to 90 of about 4,899,731 (375)
Advanced Engineering Materials, EarlyView.Patient‐specific brain phantoms can replace animal trials, aid presurgical training, and enable in silico disease research on cerebrospinal fluid and ventricles. This study presents a method to create ventricular brain phantoms from three‐dimensional magnetic resonance images brain scans, resulting in durable, tunable, reproducible models that mimic ...
Kajal Chandraprakash Jain +3 more
wiley +1 more source
Detection of Contact Binaries Using Sparse High Phase Angle Lightcurves
, 2007 We show that candidate contact binary asteroids can be efficiently identified from sparsely sampled photometry taken at phase angles >60deg. At high phase angle, close/contact binary systems produce distinctive lightcurves that spend most of the time at ...
Leone G. +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.Ni‐base superalloys produced using additive manufacturing (AM) have a different response to heat treatments when compared to their conventional counterparts. Due to such unpredictability, various alloys with industrial interest are currently overlooked in most prior AM research.
Guilherme Maziero Volpato +6 more
wiley +1 more source
Journal of Materials Research and TechnologyStudying pore networks in rocks is critical for understanding reservoir properties, with mercury intrusion porosimetry (MIP) being a key laboratory method.
Jhonatan Jair Arismendi Florez +2 more
doaj +1 more source
Contact Angle Measurement of Magnesite Mineral in Alkaline pH by Using the Simple Bubble Attachment Method [PDF]
International Journal of Economic and Environment Geology, 2018 Contact angle is one of the most important parameters for the flotation process. Researchers have performed many experiments and used many different methods to determine the contact angle.
Oktay Şahbaz, Ebru Akbulut, Ali Uçar
doaj
Liquid droplets on a free-standing glassy membrane: deformation through the glass transition
, 2017 In this study, micro-droplets are placed on thin, glassy, free-standing films where the Laplace pressure of the droplet deforms the free-standing film, creating a bulge. The film's tension is modulated by changing temperature continuously from well below
Dalnoki-Veress, Kari +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.A multimaterial approach is introduced to improve upon auxetic structures by combining two different polymers into the same reentrant honeycomb structure via additive manufacturing. The deformation behavior as well as the resulting Poisson's ratio are thereby improved significantly.
Alexander Engel +2 more
wiley +1 more source
Vacuum‐Formed Composites Based on a Polyolefin and a High Content of Biomass‐Waste Fillers
Advanced Engineering Materials, EarlyView.It is shown here that by the use of a very ductile polymer matrix, it is possible to vacuum‐form products that contain up to 25% of hard biofillers with still ductile properties. The results are promising and opens up for the use of engineered biocomposites derived from industrial side‐stream biofillers in vacuum‐formed products. A strategy to increase
Susanna K. Källbom +6 more
wiley +1 more source
Contact Angle Measurement [PDF]
, 2015 The Contact angle, where a liquid/vapor interface meets a solid surface[wiki], has been widely used to measure the wettability of a surface in physics and chemistry.
Liffiton, Faculty Advisor, Mark +1 more
core +1 more source
Experimental Investigation of Coal Dust Wettability Based on Surface Contact Angle
, 2016 Wettability is one of the key chemical properties of coal dust, which is very important to dedusting. In this paper, the theory of liquid wetting solid was presented firstly; then, taking the gas coal of Xinglongzhuang coal mine in China as an example ...
Gang Zhou +5 more
semanticscholar +1 more source