Results 71 to 80 of about 379,003 (248)

Safety and immunogenicity of rVSVΔG-ZEBOV-GP vaccination when dosed concurrent with mRNA COVID-19 vaccine booster doses in healthy African adults (EbolaCov): protocol for a phase IV, single-centre, single-blinded, randomised controlled trial

BMJ Open
Introduction Ebola virus disease remains a significant public health concern. For protection from Ebola virus, the main target populations are epidemiologically identified and often include healthcare workers and refugees.
Alice Packham, Yemisi Takwoingi, Christopher A Green, Julien Nyombayire, Jean Pierre Musabyimana, Claude Muvunyi, Karishma Gokani, Alice E Taylor, Hugor Shema, Ariane Mutabaruka, Siobhan Roche, Claudine Umuhoza   +11 more
doaj   +1 more source

SPG4 and Dementia: Expanding the Clinical Spectrum

Annals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective Hereditary spastic paraplegia (HSP) is a group of disorders characterized by progressive spasticity and lower limb weakness, with mutations in SPG4/SPAST being the most common cause. Detailed studies and clinical and molecular comparisons across different populations are missing.
Emanuele Panza, Arun Meyyazhagan, Eliseo Picchi, Gustavo Ribas, Ingrid Faber, Ryosuke Miyamoto, Preethi Basavaraju, Paolo Eusebi, Haripriya Kuchi Bhotla, Mario Stasi, Fabrizio Gaudiello, Francesco Patti, Filippo Maria Santorelli, Marcondes Cavalcante França Jr, José Luiz Pedroso, Orlando Graziani Povoas Barsottini, Hélio Afonso Ghizoni Teive, Peter Henry St George‐Hyslop, Toshitaka Kawarai, Antonio Orlacchio   +19 more
wiley   +1 more source

A metal–organic framework for efficient water-based ultra-low-temperature-driven cooling

Nature Communications, 2019
Ultra-low-temperature-actuated adsorption-driven chillers that rely on water as the cooling agent are desirable for energy-efficient and environmentally benign cooling devices. Here the authors show that the metal–organic framework of composition [Al(OH)(
Dirk Lenzen, Jingjing Zhao, Sebastian-Johannes Ernst, Mohammad Wahiduzzaman, A. Ken Inge, Dominik Fröhlich, Hongyi Xu, Hans-Jörg Bart, Christoph Janiak, Stefan Henninger, Guillaume Maurin, Xiaodong Zou, Norbert Stock   +12 more
doaj   +1 more source

Experimental Investigation of Cooling Performance a Heat Pump for Near Azeotropic Refrigerant R404A

Hittite Journal of Science and Engineering, 2017
I n this study, in order to investigate the effect of outdoor air temperatures on the performance of an air source heat pump, operated in cooling mode, using R404A refrigerant, the heat pump was tested at the outdoor air temperatures ranging from 25 °C ...
Hayati Töre, Ali Kilicarslan
doaj   +1 more source

Does Long‐Term Lower Extremity Strength Training in Adults With Knee Osteoarthritis and Varus Alignment Reduce Knee Joint Loading During Gait?

Arthritis Care &Research, EarlyView.
Objective We examined whether 18 months of strength training in individuals with knee varus alignment and medial tibiofemoral osteoarthritis (OA) reduced knee joint loads during walking compared to an attention control group. Methods This study was a secondary analysis of a randomized clinical trial that compared the effects of strength training to a ...
Stephen P. Messier, Matthew N. Vigliotti, Paige E. Rice, Brian Pietrosimone, Shannon L. Mihalko, Edward H. Ip, Richard F. Loeser, David J. Hunter, Ali Guermazi, Ryan Hill, Santiago Saldana, Kim L. Bennell, Paul DeVita   +12 more
wiley   +1 more source

Revisiting Stability Criteria in Ball‐Milled High‐Entropy Alloys: Do Hume–Rothery and Thermodynamic Rules Equally Apply?

Advanced Engineering Materials, Volume 27, Issue 6, March 2025.
The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez, Alejandro F. Manchón‐Gordón, Antonio Vidal‐Crespo, Rafael Caballero‐Flores, Jhon J. Ipus, Clara F. Conde   +5 more
wiley   +1 more source

Yield Optimization for The Extraction of Organic Compounds from Okra Leaves Wastes

Diyala Journal of Engineering Sciences
An important area of research is the extraction of organic chemicals from plants and herbs. Considering the fact that the extracts have numerous commercial and pharmacological uses.
Shaimaa Abod Hussain, Anees A. Khadom, Hameed B. Mahood   +2 more
doaj   +1 more source

Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials

Advanced Engineering Materials, EarlyView.
Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai, Xinrui Sarah Niu, Zhao Qin   +2 more
wiley   +1 more source

On the Lightweight Potential of Laser Additive Manufactured NiTi Triply Periodic Minimal Sheet Lattices

Advanced Engineering Materials, EarlyView.
This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo, Shuo Qu, Shiming Gao, Xu Song   +3 more
wiley   +1 more source

Optimization of heat sinks with plate fins in air-jet cooling

Nihon Kikai Gakkai ronbunshu, 2014
Heat density of high-load electronics such as high-performance servers and the inverters used in vehicles has been increasing as the result of higher processing speeds and computational scale, and higher output, etc.
Takayuki ATARASHI, Tetsuya TANAKA, Shigeyasu TSUBAKI   +2 more
doaj   +1 more source