Results 191 to 200 of about 65,880 (307)

Chemically‐Linked Heterostructures of Palladium Nanosheets and 2H‐MoS2

Small, EarlyView.
The photoresponse of MoS2 devices is extended to the near‐infrared region (up to 1700 nm) through chemical connection to Pd nanosheets (PdNS). A maleimide is used for covalent connection to MoS2, and a phenyl bromide moiety for linkage to the PdNS. In the absence of the chemical linker, van der Waals heterostructures show poorer enhancement of the ...
Ramiro Quirós‐Ovies, Pablo Bastante, Simon Hettler, Víctor Vega‐Mayoral, Sergio Aina, Vasileios Balos, Thomas Pucher, Andrés Castellanos‐Gomez, Raul Arenal, Juan Cabanillas‐Gonzalez, Emilio M. Pérez, Jesús Santamaría, Víctor Sebastian   +12 more
wiley   +1 more source

Construction of a Cu/Fe/S multi-active-site synergistic Fenton-like system <i>via</i> mechanically activated natural copper sulfide ore for efficient tetracycline degradation. [PDF]

RSC Adv
Gou L, Miao X, Liu Y, Zhang M, Guo M.
europepmc   +1 more source

Recycling‐Induced Copper Contamination of a 42CrMo4 Quench and Tempering Steel—Scaling and Susceptibility to Hot Shortness

steel research international, EarlyView.
In this study, the susceptibility to copper‐induced hot shortness of the alloy 42CrMo4 is investigated by different hot tensile tests, as well as by a detailed analysis of the formed oxidation products. While an enrichment of metallic copper and a penetration of the grain boundaries are observed, no critical reduction of the tensile test properties can
Alexander Gramlich, Sindokht Shayan, Nima Babaei, Aleksei Klubakov, Lena Patterer, Ulrich Krupp, Hauke Springer   +6 more
wiley   +1 more source

Investigation of the Possibilities for Infrared Diagnosis of Peirce-Smith Converters in Non-Ferrous Metallurgy. [PDF]

Materials (Basel)
Mihailov E, Choshnova D, Ivanova M, Asenova M.   +3 more
europepmc   +1 more source

Alteration of Phase Transformation Behavior and Prior Austenite Grain Structure Due to Elevated Tramp Element Concentrations in a Hypoeutectoid Steel

steel research international, EarlyView.
The phase transformation behavior of a hypoeutectoid steel is studied in comparison with alloys containing higher concentrations of tramp elements, simulating high recycling rates. The examination of microstructures reveals that the tramp elements facilitate the formation of displacive phases along with retained austenite.
Lukas Hatzenbichler, Marek Gocnik, Phillip Haslberger, Matthew Galler, Andreas Stark, Oleksandr Glushko, Jozef Keckes, Ronald Schnitzer   +7 more
wiley   +1 more source

Influence of Hydrogen Fuel Mixtures on the Oxide Scale Formation of Low‐Carbon Steels in Reheating Furnace Conditions

steel research international, EarlyView.
This work illustrates how substituting natural gas with hydrogen as fuel in the reheating furnace will influence the oxide scale formation on the steel surface. Thermogravimetric analysis and characterization techniques are used to investigate oxidation behavior and the formation of oxide phases.
Francis Gyakwaa, Susanna Airaksinen, Ville‐Valtteri Visuri, Anne Heikkilä, Timo Fabritius   +4 more
wiley   +1 more source

Engineering 3D copper foam current collectors: modification strategies and challenges toward stable lithium metal batteries. [PDF]

Sci Technol Adv Mater
Yang DR, Lai Q, Long YT, Shi X, Lu Y, Liu ZM, Gao XW, Luo WB.   +7 more
europepmc   +1 more source

Copper and copper alloys for powder metallurgy

Metal Powder Report, 1996
openaire   +1 more source

Recycling End‐of‐Life Solid Oxide Cell Interconnect Assemblies into Commercial‐Grade AISI 304 Stainless Steels

steel research international, EarlyView.
This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam, Shine‐Od Mongoljiibuu, Alexander Specht, Daniel Grüner, Dmitry Sergeev, Urs A. Peuker, Michael Müller, Ruth Schwaiger   +7 more
wiley   +1 more source

Thermodynamic Modeling of Sn–C and Fe–Sn–C Systems for the Tramp Elements Control in Steel Production

steel research international, EarlyView.
A CALculation of PHAse Diagrams thermodynamic modeling for Fe–Sn–C system is carried out. The model and the developed database can be used to calculate phase diagrams and thermodynamic properties of this system over wide temperature/composition range, and a part of a larger thermodynamic database for steel and alloy system, and effectively used to ...
Won‐Bum Park, Michael Bernhard, Youn‐Bae Kang   +2 more
wiley   +1 more source