Results 11 to 20 of about 1,082,336 (265)

Effect of Annealing Prior to Cold Rolling on the Microstructure Evolution and Energy Losses of Low-Si, Ultra-Low-C Hot-Rolled Electrical Steel

open access: yesMetals, 2020
The microstructure of a low Si, ultra-low-C, hot-rolled electrical steel strip is modified by annealing at T < To, the α→γ transformation temperature.
Héctor Ortiz Rangel   +2 more
doaj   +1 more source

Optimization and Experimental Validation of Amorphous Alloy High-Speed Asynchronous Motor for Simultaneous Reduction on Core and Copper Losses

open access: yesIEEE Access, 2023
Amorphous alloy has been proposed to replace silicon steel as the stator core material of high-speed asynchronous motors so as to reduce their core losses. However, it is found that this is at the expense of increasing the copper loss.
Jiahao Zhang   +6 more
doaj   +1 more source

FeSiCr-Based Soft Magnetic Composites with SiO2 Insulation Coating Prepared Using the Elemental Silicon Powder Hydrolysis Method

open access: yesMetals, 2023
In this work, FeSiCr powders were coated with a SiO2 insulation layer for soft magnetic composites (SMCs) through elemental silicon powder hydrolysis, without using any expensive precursors.
Chunlong Li   +3 more
doaj   +1 more source

Design of Multi-Nanoparticles Technique for Enhancing Magnetic Characterization of Power Transformers Cores

open access: yesAdvances in Electrical and Electronic Engineering, 2018
The structure of magnetic materials is an essential parameter for specifying magnetic characterization of the transformer core. This paper presents enhancing magnetic characterization of transformer cores by using new nanotechnology techniques.
Ahmed Thabet   +2 more
doaj   +1 more source

IMPROVING SUCKER ROD PUMP EFFICIENCY USING FREQUENCY CONTROLLED INDUCTION MOTOR

open access: yesИзвестия Томского политехнического университета: Инжиниринг георесурсов, 2022
Relevance. In sucker rod pump installations, the cost of the prime mover’s power use has substantial effect on the overall operational cost. Reduction in power consumption can lead to reduction in operating cost. Hence, as the sucker rod pump is dominant
Samuel Isaac Tecle   +2 more
doaj   +1 more source

Enhanced Magnetic Properties and Thermal Conductivity of FeSiCr Soft Magnetic Composite with Al2O3 Insulation Layer Prepared by Sol-Gel Process

open access: yesMetals, 2023
FeSiCr soft magnetic composites (SMCs) were fabricated by the sol-gel method, and an Al2O3/resin composite layer was employed as the insulation coating.
Qintian Xie   +5 more
doaj   +1 more source

Breakdown of the dipole approximation in core losses

open access: yesUltramicroscopy, 2011
The validity of the dipole approximations commonly used in the inelastic scattering theory for transmission electron microscopy is reviewed. Both experimental and numerical arguments are presented, emphasizing that the dipole approximations cause significant errors of the order of up to 25% even at small momentum transfer.
Löffler, S.   +4 more
openaire   +3 more sources

Core-Loss Analysis of Linear Magnetic Gears Using the Analytical Method

open access: yesEnergies, 2021
In this study, analysis of core-loss occurring in the magnetic flux modulation core of a linear magnetic gear and the core of each mover is presented, using an analytical method.
Jeong-In Lee   +5 more
doaj   +1 more source

Modifiable Factors Associated with Elevated Mean Arterial Pressure and Wide Pulse Pressure After Lower Limb Loss

open access: yesJournal of Vascular Diseases
Objectives: This study aimed to identify factors associated with mean arterial pressure and pulse pressure, while considering non-modifiable factors. Methods: This study was a retrospective cross-sectional analysis of adults with lower limb loss and no ...
Samantha Stauffer   +4 more
doaj   +1 more source

Effects of Stress on Loss and Magnetic Properties of Fe80Co3Si3B10P1C3 Amorphous Iron Cores

open access: yesMetals, 2023
The research on how to reduce energy consumption and improve the efficiency of amorphous motors has extensive coverage. This study systematically investigates the influence of internal stress induced by impregnation curing and interference fit on the ...
Wei Zheng   +8 more
doaj   +1 more source

Home - About - Disclaimer - Privacy