Results 31 to 40 of about 75,596 (317)

Corrosion Behavior of Aluminum Finstock Alloys

open access: yesMaterials Science Forum, 2002
A number of wrought AlFeSi and AlFeMnSi alloys are used for fin applications, which require an adequate corrosion resistance. The corrosion resistance of different finstock materials was compared on the basis of electrochemical passivation, pitting and salt spray experiments.
Birol, FS, Birol, Y, Slamova, M
openaire   +2 more sources

Study on Corrosion Behavior of Pressure Vessel Steel in Simulated Industrial Wharf Atmospheric Environment [PDF]

open access: yesCailiao Baohu
For studying the corrosion behavior of pressure vessel steel in simulated industrial marine atmospheric environment,the weight loss analysis,EDS,XRD and electrochemical methods were used to study the corrosion behavior of pressure vessel steel Q235 and ...
GAN Bang, MA Kaijun, CAO Gongwang, WANG Zhenyao
doaj   +1 more source

Effect of Ca Addition on Corrosion Behavior of Wrought AM60 Magnesium Alloy in Alkaline Solutions

open access: yesMetals, 2021
Magnesium (Mg) alloys possess the lowest density among structural materials, and their application in the automotive and aircraft industries might enhance fuel efficiency.
Polina Metalnikov   +3 more
doaj   +1 more source

Tribo-corrosion mechanisms of stainless steel in soft drinks [PDF]

open access: yes, 2010
Tribo-corrosion mechanisms of 316L Stainless Steel in slurries containing common household soft drinks have been studied through investigating the micro-abrasion-corrosion performance using a ball and disk apparatus which has been modified to measure the
Stack, Margaret   +4 more
core   +1 more source

Dynamic corrosion behavior of superhydrophobic surfaces

open access: yesRSC Advances, 2018
For superhydrophobic surfaces immersed in water, a thin layer of air could be entrapped in the solid/liquid interface.
C. Q. Li   +5 more
openaire   +3 more sources

Exceptional atmospheric corrosion inhibition performance of super-hydrophobic films based on the self-propelled jumping behavior of water droplets

open access: yesCorrosion Communications, 2021
Super-hydrophobic surfaces have attracted much attention for their potential applications based on the lotus effect, especially in corrosion protection. However, the lotus effect has limited application given its high dependence on external forces, such ...
Peng Wang   +4 more
doaj   +1 more source

Microstructure and Corrosion Behavior of Sn–Zn Alloys

open access: yes, 2022
In the present work, the microstructure, phase constitution, and corrosion behavior of binary Sn–xZn alloys (x = 5, 9 and 15 wt.%) were investigated. The alloys were prepared by induction melting of Sn and Zn lumps in argon.
Matej Pašák   +15 more
core   +1 more source

Effect of Rolling-Induced Microstructural Evolution and Post-Heat Treatment on the Corrosion Mechanisms of Al–Li Alloy 8090-T3 in Simulated Seawater

open access: yesCorrosion and Materials Degradation
Aluminum–lithium (Al–Li) alloys are widely used in aerospace applications because of their high strength-to-weight ratio and reduced density. However, their corrosion behavior can be significantly affected by thermomechanical processing and exposure to ...
Maheshwara Reddy Jedla   +11 more
doaj   +1 more source

EIS Investigation and Structural Characterization of Different Hot-Dipped Zinc-Based Coatings in 3.5% NaCl Solution

open access: yesInternational Journal of Electrochemical Science, 2013
Corrosion behavior of hot-dipped zinc-based coatings (pure zinc, Zn–0.25%Al and Zn–5%Al) was studied through potentiodynamic polarization test and electrochemical impedance spectroscopy in 3.5% NaCl solution.
Yang Liu, Hongying Li, Zhenguo Li
doaj   +1 more source

A comprehensive assessment of the galvanic corrosion behavior of an electrically assisted pressure joint of dissimilar stainless steel alloys under uniaxial tensile stress

open access: yesJournal of Materials Research and Technology, 2022
The effect of uniaxial tensile stress on the galvanic corrosion behavior of a dissimilar joint of stainless steel alloys is investigated in 0.5 M Na2SO4 electrolyte solution at room temperature.
Sam Yaw Anaman   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy