Results 11 to 20 of about 2,146,599 (300)
Designing coupled-resonator optical waveguide delay lines [PDF]
We address the trade-offs among delay, loss, and bandwidth in the design of coupled-resonator optical waveguide (CROW) delay lines. We begin by showing the convergence of the transfer matrix, tight-binding, and time domain formalisms in the theoretical ...
Poon, Joyce K. S. +3 more
core +3 more sources
Wide tuning-range planar filters using lumped-distributed coupled resonators [PDF]
This paper describes a discretely tunable filter topology based on lumped-distributed coupled transmission lines, particularly suitable for microelectromechanical systems switching devices.
Beach, MA +3 more
core +2 more sources
Time domain analysis of a wideband common-mode suppression filter for bent interconnects [PDF]
A technique to efficiently reduce differential-to-common mode conversion occuring at a bend discontinuity in coupled microstrip lines is investigated. Total signal integrity in the interconnect structure has been improved by minimizing the differential ...
De Zutter, Daniël +4 more
core +1 more source
The design of dual-band bandpass filters consisting of series short-circuited wire-bonded multiconductor transmission lines and shunt open stubs is thoroughly carried out in this paper. Two different configurations are studied, and closed-form analytical
Juan Jose Sanchez-Martinez +2 more
doaj +1 more source
Compact phase shifter using arbitrary length of two coupled transmission lines
This article presents a compact structure of two coupled transmission lines with two reactive loads for the tunable phase shifter using a printed‐circuit board. The proposed circuit offers size reduction and wide phase shift range.
Tso‐Jung Chang +3 more
doaj +1 more source
Compact, fiber-compatible, cascaded Raman laser [PDF]
Cascaded Raman Stokes lasing in an ultrahigh-Q silica microsphere resonator coupled to a tapered fiber is demonstrated and analyzed. With less than 900 μW of pump power near 980 nm, five cascaded Stokes lasing lines are generated.
Kippenberg, Tobias J. +2 more
core +1 more source
Shielded coupled multilayered microstrip lines analysis using HBEM [PDF]
Shielded symmetrical coupled multilayered microstrip lines analysis have been done using the hybrid boundary element method (HBEM), which is developed a few years ago at the Faculty of Electronic Engineering in Niš.
Perić Mirjana T. +2 more
doaj +1 more source
SAMBA: Superconducting antenna-coupled, multi-frequency, bolometric array [PDF]
We present a design for a multipixel, multiband (100 GHz, 200 GHz and 400 GHz) submillimeter instrument: SAMBA (Superconducting Antenna-coupled, Multi-frequency, Bolometric Array). SAMBA uses slot antenna coupled bolometers and microstrip filters.
Bock, James J. +6 more
core +1 more source
Low-Noise Voltage Controlled Oscillator with Coupled Microstrip Lines of Different Lengths
Introduction. Coupled two- or three-wire microstrip lines are often used to reduce a phase noise of voltage-controlled oscillators (VCOs). Unfortunately, the phase noise was not optimized depending on the lengths of a three-wire coupled microstrip lines ...
Aleksander V. Baranov
doaj +1 more source
Analysis of coupled exponential microstrip lines by means of a multi-step perturbation technique [PDF]
In this contribution, an iterative and adaptive multi-step perturbation technique for nonuniform transmission lines is presented and applied to the analysis of coupled exponential lines. The Telegrapher's equations for nonuniform lines, which do not have
De Zutter, Daniël +2 more
core +2 more sources

