Analysis on Fracture Toughness of the L360QS/N08825 Bimetallic Composite Pipe Welded Joint
Advances in Materials Science and Engineering, 2019 The fracture toughness of the weld and heat-affected zone (HAZ) of the L360QS/N08825 composite pipe welded joint was evaluated by a crack tip opening displacement (CTOD) test.
Bin Wang, Hongxia Lan, Bobo Lei
doaj +1 more source
Evaluation of the fracture performance of different rubberised bitumens based on the essential work of fracture [PDF]
, 2017 The fracture performance of rubberised bitumen in addition to one pre-treated with a Warm Mix Additive (Sasobit®) was investigated using different test methods measuring different damage mechanisms.
Ahmed +24 more
core +2 more sources
Finite-element analyses and fracture simulation in thin-sheet aluminum alloy [PDF]
A two-dimensional, elastic-plastic finite-element analysis was used with a critical crack-tip-opening angle (CTOA) fracture criterion to model stable crack growth in thin-sheet 2024-T3 aluminum alloy under monotonic loading after precracking at different
Bigelow, C. A. +2 more
core +1 more source
Elastic plastic fracture behavior and effect of band- overload on fatigue crack growth rate of an HSLA steel [PDF]
, 2014 Study of fracture toughness and fatigue crack growth behavior are important parameters of structural materials. These parameters can be used to predict their life, service reliability and operational safety in different conditions.
., Om Prakash
core
Fracture Assessment of Weld Joints of High-Strength Steel in Pre-Strained Condition
Applied Sciences, 2019 Unstable fractures tend to occur after ductile crack initiation or propagation. In most collapsed steel structures, a maximum 15% pre-strain was recorded, at the steel structural connections, during the great earthquake of 1995, in Japan. Almost-unstable
Gyubaek An +3 more
doaj +1 more source
Strip Yield Model Numerical Application to Different Geometries and Loading Conditions [PDF]
A new numerical method based on the strip-yield analysis approach was developed for calculating the Crack Tip Opening Displacement (CTOD). This approach can be applied for different crack configurations having infinite and finite geometries, and ...
Forman, Royce +3 more
core +1 more source
Reproducibility of Pop-Ins in Laboratory Testing ofWelded Joints [PDF]
, 2000 The pop-in phenomenon, quite common in fracture mechanics tests of welded joints, corresponds to a brittle crack initiation grown from a local brittle zone (LBZ) that is arrested in reaching the higher toughness material that surrounds this LBZ.
Berejnoi, C. +2 more
core +4 more sources
Influence and evaluation of constraint on fracture toughness in pipeline research [PDF]
, 2012 Accessing nowadays fossil fuel reserves requires a strain-based design approach. Within such design, the ductile tearing resistance is a key parameter in assessing the defect tolerance. To determine this tearing resistance, full scale (pressurized) tests
De Waele, Wim +3 more
core
Experimental and numerical analysis of deformation patterns in notched heterogeneous welds [PDF]
, 2017 Standardized weld flaw assessment techniques assume the weld region to be homogeneous which is a strong idealisation of reality. Characterising the effects of heterogeneous properties of welds through the analysis of deformation patterns and slip lines ...
De Waele, Wim +4 more
core +2 more sources
X70 STEEL CRITICAL CTOD VALUE ANSYS CALCULATION
Jixie qiangdu, 2015 With the development of ocean engineering,increase in the number of project exploration of Marine oil and gas,natural gas and oil transportation engineering are increasingly developed.
YE YunQin, MIAO ZhangMu, ZHANG BuAi
doaj