Results 91 to 100 of about 5,709 (204)
QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2022 Yoshifumi Takaki +3 more
openaire +1 more source
The Egyptian Heart Journal, 2014 The aim of this study was to evaluate power of identification of silent cardiac target organ damage (TOD) in population receiving primary prevention with the use of biomarkers.
Yahia M. Elrakshy, Akram M. Fayed
doaj +1 more source
Convenient method for estimation of JIC by CTOD.
TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 1985 The JSME standard (S-001) for determination of JIC recommended to draw the blunting line or to measure the stretched zone width by an electron microscope. However, this procedure is taken trouble to measure these values. Following the British Standard BS5762, the CTOD value, Φi, at the onset of the ductile fracture is determined by using the CTOD ...
Shun-ichi KAWANO +2 more
openaire +2 more sources
A Literature Review of Incorporating Crack Tip Plasticity into Fatigue Crack Growth Models. [PDF]
Materials (Basel), 2023 Garcia-Gonzalez A +4 more
europepmc +1 more source
Influence of the mesh size on plastic CTOD
, 2021 The Crack Tip Opening Displacement (CTOD) is an elastic-plastic fracture mechanics parameter usually employed as a measurement of fracture toughness and to explain the fatigue crack growth. This parameter can be decomposed on two different components: the elastic and plastic one.
Sanchez-Mancera, J. +3 more
openaire +2 more sources
Application of CTOD in Atomistic Modeling of Fracture
Procedia Materials Science, 2014 AbstractIn atomistic modeling of fracture, most examinations are based on the Griffith energy, calculated from the surface energy, and the stress intensity factor derived from continuum mechanical formulations. Both approaches, however, reflect continuum mechanics and lack the direct connection to the atomistic crack tip mechanisms, and it is thus ...
openaire +1 more source
Creep fatigue life prediction for engine hot section materials (isotropic) [PDF]
The first two years of a two-phase program aimed at improving the high temperature crack initiation life prediction technology for gas turbine hot section components are discussed.
Lin, Li-Sen Jim +2 more
core +1 more source
Mechanical, microstructural and fracture studies on inconel 825-SS316L functionally graded wall fabricated by wire arc additive manufacturing. [PDF]
Sci Rep, 2023 Senthil TS, Babu SR, Puviyarasan M.
europepmc +1 more source
Comparison of Fracture Toughness in the Coarse-Grain Heat-Affected Zone of X80 Pipelines Girth-Welded under Conventional and Ultra-Low Heat Input. [PDF]
Materials (Basel), 2022 Liu S, Ba L, Li C, Di X.
europepmc +1 more source
Effect of H2S Corrosion on the Fracture Toughness of the X80 Pipeline Steel Welded Joint. [PDF]
Materials (Basel), 2022 Wang X, Wang D, Deng C, Li C.
europepmc +1 more source