Results 11 to 20 of about 80,443 (263)
Development of Emulsion as Extreme Pressure Cutting Fluid [PDF]
Cailiao Baohu, 2021 Traditional oil-based cutting fluids hardly meet the severe operation conditions.Hence, a kind of emulsion as extreme pressure emulsion cutting fluid was developed, which consisted of lubricant, antirust additive, stabilizer, refined mineral oil, biocide
ZENG Hai-yan, WANG Yi-zhu, XIONG Hong-qi
doaj +1 more source
Nihon Kikai Gakkai ronbunshu, 2019 This paper describes the novel on-machine measurement method of tool edge shape by using fluorescence emitted from cutting fluid. Tool wear and chipping are a major factor of decreasing machining accuracy.
Kohei MATSUMOTO +2 more
doaj +1 more source
Applied Sciences, 2017 Following a comprehensive review on titanium machining and methods of cutting fluid application, this paper presents a new Controlled cutting fluid impinging supply system (Cut‐list) developed to deliver an accurate amount of cutting fluid into the ...
Salah Gariani +3 more
doaj +1 more source
Mekanika, 2017 There are many factor affecting the quality of product that are produced from milling machine process. The quality is mostly about surface roughness and precision.
Widhaya Bastian Purnama +2 more
doaj +1 more source
An integrated approach for cutting fluid selection using multiple attribute decision making methods
Journal of Mechanical Engineering and Sciences, 2021 The choice of most appropriate cutting liquid in any machining process should be performed to attain maximum benefit. Selection of cutting fluid needs more than one dimension.
S. Dhanalakshmi, T. Rameshbabu
doaj +1 more source
Engineering Science and Technology, an International Journal, 2016 Recently the concept of hard turning has gained much attention in the metal cutting industry. In hard turning, multiple operations can be performed in single step, thereby it replaces the traditional process cycle.
P. Sam Paul +2 more
doaj +1 more source
Case Studies in Construction Materials, 2022 This study investigated the potential use of metalworking (cutting) fluid as an surface additive in the production of medium density fiberboard (MDF). The cutting fluid was sprayed on the mat surface of the fiberboard at different loading levels, of 3.5 ...
Nadir Ayrilmis, Samet Gürsoy
doaj +1 more source
Journal of Manufacturing and Materials Processing, 2020 The tribological effect of cutting fluids in the machining processes to reduce the friction in the cutting zone is still widely unknown. Most test benches and procedures do not represent the contact conditions of machining processes adequately ...
Thomas Lakner, Marvin Hardt
doaj +1 more source
Analysis of Microstructure and Chip Formation When Machining Ti-6Al-4V
Metals, 2018 Microstructure and chip formation were evaluated during the step shoulder down-milling of Ti-6Al-4V using a water-miscible vegetable oil-based cutting fluid.
Islam Shyha +3 more
doaj +1 more source
Pengaruh Metode Minimum Quantity Lubrication (MQL) Terhadap Nilai Kekasaran Permukaan
Rekayasa, 2020 Sebuah alat kendali semprotan cutting fluid pada minimum quantity lubrication (MQL) telah berhasil dibuat. Alat yang bekerja dengan sistem Arduino ini dihubungkan dengan sensor suhu yang diletakkan pada sisi pahat dan berhasil mengendalikan kapan cutting
Dicky Aprilian Nugraha +2 more
doaj +1 more source