Results 21 to 30 of about 401,853 (305)
Journal of Manufacturing and Materials Processing, 2020 The tribological effect of cutting fluids in the machining processes to reduce the friction in the cutting zone is still widely unknown. Most test benches and procedures do not represent the contact conditions of machining processes adequately ...
Thomas Lakner, Marvin Hardt
doaj +1 more source
Case Studies in Construction Materials, 2022 This study investigated the potential use of metalworking (cutting) fluid as an surface additive in the production of medium density fiberboard (MDF). The cutting fluid was sprayed on the mat surface of the fiberboard at different loading levels, of 3.5 ...
Nadir Ayrilmis, Samet Gürsoy
doaj +1 more source
Teknika, 2017 There are many factor affecting the quality of product that are produced from milling machine process. The quality is mostly about surface roughness and precision.
Widhaya Bastian Purnama
doaj +1 more source
Pengaruh Metode Minimum Quantity Lubrication (MQL) Terhadap Nilai Kekasaran Permukaan
Rekayasa, 2020 Sebuah alat kendali semprotan cutting fluid pada minimum quantity lubrication (MQL) telah berhasil dibuat. Alat yang bekerja dengan sistem Arduino ini dihubungkan dengan sensor suhu yang diletakkan pada sisi pahat dan berhasil mengendalikan kapan cutting
Dicky Aprilian Nugraha +2 more
doaj +1 more source
Analysis of Microstructure and Chip Formation When Machining Ti-6Al-4V
Metals, 2018 Microstructure and chip formation were evaluated during the step shoulder down-milling of Ti-6Al-4V using a water-miscible vegetable oil-based cutting fluid.
Islam Shyha +3 more
doaj +1 more source
The effect of an organic pentasulfide EP additive in turning and milling operations [PDF]
, 2014 Coopération avec Ecole Centrale LyonBecause a cutting fluid could be equally used for different cutting operations, this study proposed to investigate the behavior of a well-known extreme-pressure additive (pentasulfide) in both turning and milling ...
BIERLA, Aleksandra +4 more
core +4 more sources
Archives of Metallurgy and Materials, 2017 This paper presents the influence of cutting parameters (Depth of cut, feed rate, spindle speed and cutting fluid flow rate) on the surface roughness and flank wear of physical vapor deposition (PVD) Cathodic arc evaporation coated TiAlN tungsten carbide
Moganapriya C. +4 more
doaj +1 more source
Preparation of water-soluble nanographite and its application in water-based cutting fluid [PDF]
, 2013 Water-soluble nanographite was prepared by in situ emulsion polymerization using methacrylate as polymeric monomer. The dispersion stability and dispersion state of graphite particles were evaluated by UV-visible spectrophotometry and scanning electron ...
Qiang Chen +4 more
core +1 more source
LubricantsCutting fluid can improve the heat dissipation and lubrication in the cutting process and thus increase the machining quality. In this work, a pollution-free alcohol solution was proposed as the cutting fluid in an ultra-precision cutting process to ...
Xian Wu +4 more
doaj +1 more source
Engineering Science and Technology, an International Journal, 2016 Hard turning with minimal fluid application is a recently developed technique to alleviate the problem associated with cutting fluid. During this process, very small quantity of cutting fluid is applied as a narrow high velocity pulsing jet at the ...
R. Robinson Gnanadurai, A.S. Varadarajan
doaj +1 more source