Machinability of inconel 718 during turning: Cutting force model considering tool wear, influence on surface integrity [PDF]
Journal of Materials Processing Technology, 2020 Machining accuracy can be compromised by elastic workpiece deformation and subsurface residual stress introduction during cutting. In order to anticipate the impact of cutting forces and surface integrity evolutions on finished surface and its ...
Bastien Toubhans +4 more
semanticscholar +2 more sources
An investigation on micro cutting mechanics: Modelling, simulations and experimental case studies [PDF]
, 2014 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University London.Micro cutting is becoming increasingly important since miniature and micro components/products have become more and more demanded in precision ...
Sawangsri, Worapong
core +7 more sources
PCD tool wear in cutting SiCp/6005Al composites
Jin'gangshi yu moliao moju gongcheng, 2023 To study the tool wear mechanism of turning SiCp/6005Al and the influence of tool wear on cutting force, cutting temperature and workpiece surface quality, cutting experiments at different speeds V and different feed speeds f were carried out.
Jieqiong LIN, Ru JIA, Yan ZHOU, Yan GU
doaj +3 more sources
Cutting Force Control Applying Sensorless Cutting Force Monitoring Method
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2010 Intelligent machine tools require the functions of high-accurate process monitoring and adaptive control to fit the optimum process condition in each workpieces.
Daisuke KURIHARA +2 more
doaj +1 more source
Evaluation of cutting force of high-performance fibers’ dynamic cutting behaviour
Journal of Industrial Textiles, 2022 An analysis of fiber mechanics during cutting is conducted using a rotating cutting set up. It was found that high cutting speeds, low cutting angles, and high cutting normal forces lead to low values of cutting force.
Magdi El Messiry +3 more
doaj +1 more source
An Innovative Experimental Study of Corner Radius Effect on Cutting Forces [PDF]
, 2014 The cutting forces are often modelled using edge discretisation methodology. In finish turning, due to the smaller corner radii, the use of a local cutting force model identified from orthogonal cutting tests poses a significant challenge. In this paper,
BISSEY BRETON, Stéphanie +4 more
core +1 more source
Instantaneous rigid force model based on oblique cutting to predict milling force
Nihon Kikai Gakkai ronbunshu, 2017 In end milling, in order to improve machining efficiency and accuracy, instantaneous rigid force model is widely used to predict cutting force and improve cutting conditions.
Kazuki KANEKO +3 more
doaj +1 more source
Improvement of Cutting Forces Modeling Based on Oriented Cutting Tests [PDF]
, 2013 In order to predict the characteristics of the machined part, such as geometry, surface roughness and fatigue or corrosion resistance, the cutting forces values should be known as precisely as possible.
Gérard Poulachon +10 more
core +1 more source
An expert mill cutter and cutting parameters selection system incorporating a control strategy [PDF]
, 2008 This paper discusses the selection of tools and cutting parameters in milling operations. To carry out this research, an expert system has been developed based on numerical methods of performance evaluation.
De la Sen Parte, Manuel +1 more
core +4 more sources
Effect of chip load and spindle speed on cutting force of Hastelloy X
Journal of Mechanical Engineering and Sciences, 2020 Research on cutting force revealed that the cutting force decreases as cutting speed increases, which is in line with Salomon’s Theory. However, the fundamental behaviour was never clearly explained because most studies had focused on increasing the ...
Nor Aznan Mohd Nor +4 more
doaj +1 more source