Results 21 to 30 of about 3,517,652 (393)
Effect of chip load and spindle speed on cutting force of Hastelloy X
Journal of Mechanical Engineering and Sciences, 2020 Research on cutting force revealed that the cutting force decreases as cutting speed increases, which is in line with Salomon’s Theory. However, the fundamental behaviour was never clearly explained because most studies had focused on increasing the ...
Nor Aznan Mohd Nor +4 more
doaj +1 more source
Machines, 2022 Conical picks are applied to rock breaking, and the cutting parameters greatly influence cutting performance and rock damage. A conical pick rock-cutting numerical simulation model and software to provide a quantitative analysis of rock damage are ...
Zhiwen Wang +4 more
doaj +1 more source
An Innovative Experimental Study of Corner Radius Effect on Cutting Forces [PDF]
, 2014 The cutting forces are often modelled using edge discretisation methodology. In finish turning, due to the smaller corner radii, the use of a local cutting force model identified from orthogonal cutting tests poses a significant challenge. In this paper,
BISSEY BRETON, Stéphanie +3 more
core +5 more sources
Diamond turning of soft semiconductors to obtain nanometric mirror surfaces [PDF]
, 2002 Diamond cutting is a viable alternative to grinding and polishing in the fabrication of high-quality soft semiconductors. Investigation of indentation provides useful information for understanding the practical diamond cutting process of brittle ...
Fang, Fengzhou Z. +2 more
core +1 more source
Device for in-situ cleaving of hard crystals [PDF]
, 2005 Cleaving crystals in a vacuum chamber is a simple method for obtaining atomically flat and clean surfaces for materials that have a preferential cleaving plane.
A. Renner +4 more
core +2 more sources
Forces and Plastic Work in Cutting
CIRP Annals, 1983 Prolific considerations in C.I.R.P. give rise to a further step in the development of a plastic cutting model. Basically two different primary shear zone geometries are assumed: with one and with two shear planes respectively. For both geometries two energetically different approaches are developed.
Dautzenberg, J.H. +2 more
openaire +2 more sources
A review of recent perspectives on biomechanical risk factors associated with anterior cruciate ligament injury [PDF]
, 2014 There is considerable evidence to support a number of biomechanical risk factors associated with non-contact anterior cruciate ligament (ACL) injury. This paper aimed to review these biomechanical risk factors and highlight future directions relating to ...
Boden B. P. +18 more
core +2 more sources
Cutting Force Estimation Considering the Specific Cutting Force Constant
Journal of the Korean Society of Manufacturing Process Engineers, 2019 Few studies have been conducted regarding theoretical turning force modelling while considering cutting constant. In this paper , a new cutting force modelling technique was suggested which considers the specific cutting force coefficients for turning.
Jong-Do Kim, Moon-Chul Yoon
openaire +1 more source
Forces Shapes in 3-Axis End-Milling: Classification and Characteristic Equations
Journal of Manufacturing and Materials Processing, 2021 In 3-axis milling, cutting force analysis represents one of the main methods to increase the quality and productivity of the process. In this context, cutting force shape gives information of both monitoring and prediction of the cutting process. However,
Niccolò Grossi +3 more
doaj +1 more source