Results 41 to 50 of about 667,725 (214)
The analysis of cutting forces for hardened steel milling
Омский научный вестник, 2023 Micro milling is a widely used manufacturing method. The main purpose of this study is to analyze the cutting forces in corrosion-resistant, heat-resistant steel 14Kh17N2.
D. S. Makashin
doaj +1 more source
Effect of surface finishing such as sand-blasting and CrAlN hard coatings on the cutting edge’s peeling tools’ wear resistance [PDF]
, 2009 The authors would like to thank IonBond (Chassieu-France) who made the sand-blasting treatments and the Regional Council of Burgundy and CTBA (Wood and Furniture Technical Centre) for their financial support.The aim of this study is first to define the ...
BENLATRECHE, Yacine +4 more
core +4 more sources
Study of Cutting Edge Temperature and Cutting Force of End Mill Tool in High Speed Machining
MATEC Web of Conferences, 2017 A wear of cutting tools during machining process is unavoidable due to the presence of frictional forces during removing process of unwanted material of workpiece.
Kiprawi Mohammad Ashaari +4 more
doaj +1 more source
Dynamic analysis of runout correction in milling [PDF]
, 2010 Tool runout and its effects is an important area of research within modelling, simulation, and control of milling forces. Tool runout causes tool cutting edges to experience uneven forces during milling.
Diez Cifuentes, Eduardo +3 more
core +2 more sources
Advances in Mechanical Engineering, 2015 Minimum quantity lubrication is a technique to have the advantages that cutting fluids bring yet keeping their use at minimum. For the cutting fluids, inedible vegetable oils are potential for minimum quantity lubrication machining.
Mohamed Handawi Saad Elmunafi +2 more
doaj +1 more source
Tehnički Glasnik, 2023 When machining difficult-to-cut metal materials often used to make sheet metal forming tools, excessive cutting force jumps often break the cutting edge. Therefore, this research developed a system of three neural network models to accurately predict the
Uroš Župerl, Miha Kovačič
doaj +1 more source
Investigation of tool geometry effect and penetration strategies on cutting forces during thread milling [PDF]
, 2014 The application of thread milling is increasing in industry because of its inherent advantages over other thread cutting techniques. The objective of this study is to investigate the effect of milling cutter tool geometry on cutting forces during thread ...
BRENDLEN, Romain +3 more
core +3 more sources
Discrete Cutting Force Model for 5-Axis Milling with Arbitrary Engagement and Feed Direction [PDF]
, 2017 5-axis machining operations bring new challenges for predicting cutting forces. Complex tool workpiece engagements and tool orientations make it difficult to adapt 3-axis process models for 5-axis operations.
Berglind, L., Ozturk, E., Plakhotnik, D.
core +1 more source
Determination of Optimum Machining Parameters in Machining Rene 41 Superalloy Depending on Cutting Speed [PDF]
E3S Web of ConferencesRene 41 superalloy developed to withstand severe mechanical stresses and high temperature operation, and are widely used in aircraft and space vehicles, especially nickel-based ones, due to their high corrosion resistance.
Altin Abdullah +3 more
doaj +1 more source
Mehmet Akif Ersoy Üniversitesi Fen Bilimleri Enstitüsü, 2020 In this study, cutter vibrations, wear conditions and cutting forces are observed during jet-assisted turning under coolant pressure conditions. Inconel 718 material is used as a thread.
Orhan GÜNGÖR, Hüseyin Bilal MACİT
doaj +1 more source