Results 21 to 30 of about 70,301 (265)
Dynamic Response of Cement–Fly Ash Mixed Pile Composite Foundation Under Wave Load
CFMPs (cement and fly ash mixing piles) are used to reinforce fly ash foundation to solve the problem of a large amount of fly ash accumulation in coastal areas.
Haojin Zhang +3 more
doaj +1 more source
The crack growth behavior of fiber metal laminates (FMLs) with fiber orientations of 90°/0° and 45°/45° to load direction was investigated with varying stress ratios of the cyclic constant load.
Anindito Purnowidodo +3 more
doaj +1 more source
Wellbore instability is one of the most serious issues faced in the drilling process. During drilling operations, the cyclic loads applied on the fractured formation progressively modify the initial parameters (i.e., length and width) of the fractured ...
Arnaud Regis Kamgue Lenwoue +7 more
doaj +1 more source
Stud plays an important role in the connection of steel-concrete composite bridge (SCCB). The stud is under pull-out load in the negative moment zone of SCCB.
Fuhai Li +7 more
doaj +1 more source
Cyclic load is widely adopted in laboratory to simulate the effect of train load on ballast bed. The effectiveness of such load equivalence is usually testified by having similar results of key concerns of ballast bed, such as deformation or stiffness ...
Longlong Fu +3 more
doaj +1 more source
Horizontal Cyclic Bearing Characteristics of Bucket Foundation in Sand for Offshore Wind Turbines
During the service period, the offshore wind turbine foundation mainly bears the wind load from the upper structure and the periodic loads such as wave load and sea currents from the lower structure. Long-term cyclic loads have an important impact on the
Hanbo Zhai, Puyang Zhang, Junqi Ren
doaj +1 more source
Piles Subjected to Torsional Cyclic Load: Numerical Analysis
Pile foundations supporting large structures (such as high-rise buildings, oil drilling platforms, bridges etc). are often subjected to eccentric lateral load (in addition to the vertical loads) due to the action of wind, waves, high speed traffic, and ...
Sanjay Shrawan Nimbalkar +3 more
doaj +1 more source
The effect of varying loading directions and loading levels on crack growth at 2D- and 3D-mixed-mode-loadings [PDF]
While product’s operation the loading situation commonly changes. The local loading situation on an existing crack then can shift to a combined loading, composed of mode I, mode II and mode III, and consequently influence the product’s durability ...
A. Eberlein, H.A. Richard
doaj +2 more sources
A load capacity of cyclic loaded reinforced concrete beams
In this paper, an effect of cyclic and variable loads on the capacity of reinforced concrete beams is investigated. The study was conducted on 28 reinforced concrete beams including 12 two-span beams - statically indeterminate and 16 simply supported ...
Barbara Goszczyńska +3 more
doaj +1 more source
A creep damage constitutive model of loaded yellow sandstone under cyclic water intrusion
For the rock mass of roadbed slope, its long-term stability is often compromised due to the lasting impact of both water-drying cycle and unidirectional load under rainfall.
GAO Yongqing, GAO Maosheng, YAN Yushui
doaj +1 more source

