Results 101 to 110 of about 126,861 (303)
Machine Learning: Science and TechnologyAn extendable, efficient and explainable Machine Learning approach is proposed to represent cyclic plasticity and replace conventional material models based on the Radial Return Mapping algorithm.
Stefan Hildebrand, Sandra Klinge
doaj +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
A combined experimental-numerical study to tensile behaviour of limestone [PDF]
, 2003 In this paper, a combined experimental-computational study of double-edge notched stone specimen subject to cyclic tensile loading is presented. In the experimental part, the load-deformation response and the local displacement field are recorded.
, +4 more
core
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Closed form solution of the return mapping algorithm in elastoplasticity [PDF]
, 2017 In the present work a return mapping algorithm is discussed for small strain elastoplasticity boundary value problems with an exact closed form solution of the local constitutive equations.
De Angelis, Fabio, Taylor, Robert L.
core
Cyclic plasticity and fatigue of metals [PDF]
Le Journal de Physique IV, 1993 This report is a survey of the cyclic deformation and fatigue behaviour of selected engineering steels and alloys. Emphasis is placed on the important roles of the cyclic slip mode and the stability of the microstructure during cyclic stressing and on the conditions of fatigue testing with respect to the failure mechanisms and fatigue life.
openaire +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Mathematical simulation of low cycle fatigue of high-loaded engine parts
Propulsion and Power Research, 2018 The paper discusses main aspects of low cycle fatigue influence on the lifetime of engine parts. The importance and history of the problem, the main experiments and the effects impacting the low cycle fatigue of structural materials are described.
Yury M. Temis
doaj +1 more source
Non-proportional deformation paths for sheet metal: experiments and models [PDF]
, 2009 For mild steel, after significant plastic deformation in one direction, a subsequent deformation in an orthogonal direction shows a typical stress overshoot compared to monotonic deformation. This phenomenon is investigated experimentally and numerically
Boogaard, A.H. van den, Riel, M. van
core +2 more sources