Results 251 to 260 of about 7,076,686 (288)
Some of the next articles are maybe not open access.

Modeling of fatigue crack growth closure considering the integrative effect of cyclic stress ratio, specimen thickness and Poisson’s ratio

Chinese Journal of Mechanical Engineering, 2012
Key components of large structures in aeronautics industry are required to be made light and have long enough fatigue lives. It is of vital importance to estimate the fatigue life of these structures accurately. Since the FCG process is affected by various factors, no universal model exists due to the complexity of the mechanisms.
Jiantao Liu   +3 more
openaire   +1 more source

Dense Granular Columns in Liquefiable Ground. I: Shear Reinforcement and Cyclic Stress Ratio Reduction

Journal of Geotechnical and Geoenvironmental Engineering, 2016
AbstractThe installation of dense granular columns by various construction techniques can be used to mitigate liquefaction through a combination of densification, increase of lateral stresses, reinforcement, and drainage. The contributing mechanism of shear reinforcement is isolated and explored using nonlinear three-dimensional (3D) finite-element (FE)
Deepak Rayamajhi   +3 more
openaire   +1 more source

Effect of cyclic shear stress ratio on cyclic behavior of clay under multidirectional shear loading

Marine Georesources & Geotechnology, 2023
Hongxu Jin, Daoming Pan, Lin Guo, Li Shi
openaire   +1 more source

Effect of the stress ratio on the fatigue and cyclic creep of low alloy steels. Report 2

Strength of Materials, 1991
Methods have been developed for experimentally determining the fatigue limit, which has been called by the authors the minimum cyclic creep limit, and the stess limits at various cyclic stress ratios R, called the cyclic creep limits. During the cyclic creep limit tests, levels of residual stresses are achieved which are equal to the residual stresses ...
openaire   +1 more source

Cyclic fatigue crack growth in silicon nitride: Influences of stress ratio and crack closure

Acta Metallurgica et Materialia, 1995
Abstract The characteristics of cyclic fatigue crack growth was investigated in silicon nitride which hardly shows rising R-curve behavior, using single edge precraked beam specimens. Crack growth behavior is known to be explicable by a power law relationship including both the stress intensity range ΔK and the maximum stress intensity Kmax; i.e.
openaire   +1 more source

Measurements on the residual resistivity ratio (RRR) of high purity aluminium under cyclic mechanical stresses

IEEE Transactions on Magnetics, 1996
High purity aluminium used for the stabilisation of superconducting cable achieves very low electrical resistivity at 4.2 K even at high magnetic fields. However, the resistivity is strain dependent, especially cyclic strain dependent. In aluminium stabilised superconducting magnets a strain induced increase of the resistivity can be observed after ...
I.L. Horvath   +3 more
openaire   +1 more source

AN APROACH FOR CYCLIC STRESS RATIO OF LIQUEFIED OR UNLIQUEFIED SOILS

2006
Bu çalışmada, yinelemeli (tekrarlı) yüklerin belirlenmesi için kullanılan deprem ile zemin parametrelerine, zeminin kayma dalga hızları (Vs) ve deprem dalgasının hakim periyodu da (T) eklenerek alternatif bir analitik ilişki geliştirilmiş ve kayma gerilme oranı (KGO) olarak isimlendirilmiştir.
openaire   +1 more source

Critical Cyclic Stress Ratio of Reconstituted Silty Clay under the Cyclic Loading

Journal of Convergence Information Technology, 2012
Gang Yang -   +3 more
openaire   +1 more source

Home - About - Disclaimer - Privacy