Results 51 to 60 of about 210,748 (195)

AC-DC DAB Converter with Power Factor Correction

open access: yesEnergies, 2022
AC-DC conversion is required in many applications, and in some of them isolation is strictly required, certainly while maintaining characteristics such as a high power factor and low input current THD. In this paper, an AC-DC converter, comprising a full-bridge diode rectifier and a dual-active-bridge (DAB) converter, is utilized to fulfill these ...
Pablo Guzmán   +5 more
openaire   +2 more sources

Adaptive Control of Photovoltaic Systems Based on Dual Active Bridge Converters

open access: yesComputation, 2022
Dual active bridge converters (DAB) are used to interconnect photovoltaic (PV) generators with AC and DC buses or isolated loads. However, a controller is needed to provide a stable and efficient operation of the DAB converter when the PV generator must ...
Elkin Edilberto Henao-Bravo   +2 more
doaj   +1 more source

Peak Current Control and Feed-Forward Compensation for the DAB Converter

open access: yes2019 IEEE International Conference on Industrial Technology (ICIT), 2019
This paper presents a double band peak current control for the DAB converter that permits to avoid the risk of transformer saturation. Additionally, feed-forward compensation is employed to achieve a fast transient response under load variations. The proposal is described, analyzed, and numerically simulated.
Nimrod Vázquez, Marco Liserre
openaire   +2 more sources

Single- and Three-Phase Dual-Active-Bridge DC–DC Converter Comparison for Battery Electric Vehicle Powertrain Application

open access: yesEnergies
Dual-active-bridge (DAB) DC–DC converters are of great interest for DC–DC conversion in battery electric vehicle (BEV) powertrain applications. There are two versions of DAB DC–DC converters: single-phase (1p) and three-phase (3p) architectures.
Nasr Guennouni   +2 more
doaj   +1 more source

Conexão série-série de módulos CC-CC isolados [PDF]

open access: yes, 2015
Tese (doutorado) - Universidade Federal de Santa Catarina, Centro Tecnológico. Programa de Pós-Graduação em Engenharia Elétrica, Florianópolis, 2015Esta tese apresenta a associação de conversores CC-CC de duas portas conectados em série-série tanto na ...
Bottion, Antonio José Bento
core  

A modified two-stage isolated bidirectional buck-DAB converter with a full-load ZVS range

open access: yesFrontiers in Energy Research
A modified two-stage buck-DAB (MBDAB) converter is proposed to improve the performance of the traditional two-stage buck-DAB (TSBDAB) converter. In the MBDAB converter, the DAB can work with fixed voltage gain and voltage-matched condition under a wide ...
Jinliang Li   +5 more
doaj   +1 more source

Efficiency Optimization of a Dual Active Bridge Converter with a Variable Inductor for Battery Charging Applications

open access: yesEletrônica de Potência
This paper investigates the efficiency improvements achieved by using a Variable Inductor (VI) in a Dual Active Bridge (DAB) converter for battery charging applications.
Conrado G. Marques   +5 more
doaj   +1 more source

Unison Duty-Phase Peak Current Control for Pole Point Inductor-Based Dual Active Bridge Converter With Zero DC Bias Current

open access: yesIEEE Access
The DC-DC converters capable of high gain with bidirectional capability are used in the grid in conjunction with energy storage systems consisting of fuel cells, batteries, and supercapacitors to support the peak load times.
R. Nitheesh   +2 more
doaj   +1 more source

Stability analysis of digitally controlled dual active bridge converters

open access: yesJournal of Modern Power Systems and Clean Energy, 2017
The dual active bridge (DAB) converters are widely used in the energy storage equipment and the distributed power systems. However, the existence of switching nonlinearity and control delay can cause serious stability problem to the DAB converters. Thus,
Ling SHI   +5 more
doaj   +1 more source

Efficiency optimisation of ZVS isolated bidirectional DAB converters [PDF]

open access: yesIET Power Electronics, 2018
This study presents a control method for isolated bidirectional dual‐active‐bridge converters to optimise the efficiency by achieving the zero‐voltage switching (ZVS) in high‐voltage applications, which the switching losses are the major issues. At light‐load condition, the duty control algorithm is proposed to achieve the ZVS for all switches while ...
Dung N.A.   +4 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy