Results 11 to 20 of about 871,220 (308)
Impact of converter interface type on the protection requirements for DC aircraft power systems [PDF]
The utilization of converter interfaces has the potential to significantly alter the protection system design requirements in future aircraft platforms.
Burt, Graeme +3 more
core +4 more sources
With the expansion of E-mobility technology, the demand for Medium-Voltage (MV) Electric Buses (E-buses) charging infrastructure has significantly increased.
Mena ElMenshawy, Ahmed Massoud
doaj +1 more source
The Alternate Arm Converter: A New Hybrid Multilevel Converter With DC-Fault Blocking Capability [PDF]
This paper explains the working principles, supported by simulation results, of a new converter topology intended for HVDC applications, called the alternate arm converter (AAC).
Merlin, Michael MC +6 more
core +1 more source
New Modular Multilevel DC–DC Converter Derived from Modified Buck–Boost DC–DC Converter
Raising the electrification ratio to 100% is still a formidable challenge in Indonesia, especially in the remote areas of the eastern part of the archipelago. A DC microgrid system is one of the most viable solutions to increase the electricity supply in
Ridha D. N. Aditama +5 more
doaj +1 more source
An analysis of bidirectional superposed dual active bridge DC-DC converter with synchronous rectifier [PDF]
This paper describes the principles and characteristics of a novel bidirectional superposed dual active bridge DC-DC converter with synchronous rectifier, which has a mechanism formed from two bridge-type converters that are linked through superposition ...
Takayuki Kimura +7 more
core +1 more source
The AC voltage control of a DC/DC converter based on the modular multilevel converter (MMC) is considered under normal operation and during a local DC fault.
Rui Li, John E. Fletcher
doaj +1 more source
A New Approach Integrated Magnetics Double-Frequency DC/DC Converter
Double-frequency DC/DC converter can improve switching frequency and reduce switching loss than single-frequency DC/DC converter. However, it is heavy and large due to its small high-frequency inductor and large low-frequency inductor.
Shengwei Gao, Hao Wang
doaj +1 more source
Evaluation of an un-regulated input isolated DC–DC converter using WBG devices
The paper presents the design and analysis of an un-regulated isolated DC–DC converter using wide band gap (WBG) devices for low-voltage, high current applications.
Rakesh Ramachandran, Morten Nymand
doaj +1 more source
Bidirectional DC-DC converter is needed in the energy storage system. The converter topology used in this paper was a non-isolated bidirectional DC-DC buck-boost converter.
Eka Prasetyono +3 more
doaj +1 more source
A Soft Switched DC-DC Boost Converter for Use in Grid Connected Inverters [PDF]
This paper presents a soft-switching DC-DC boost converter, which can be utilized in renewable energy systems such as photovoltaic array, and wind turbine connections to infinite bus of a big power network, using grid connected inverters. In the proposed
S. Jalilzadeh, M. Pakdel
doaj +1 more source

