Results 21 to 30 of about 451,093 (362)
Multilevel DC–DC Power Conversion System With Multiple DC Sources [PDF]
IEEE Transactions on Power Electronics, 2008 A multilevel DC-DC power conversion system with multiple DC sources is proposed in this paper. With this conversion system, the output voltage can be changed almost continuously without any magnetic components. With this magnetic-less system, very high temperature operation is possible.
Miaosen Shen +2 more
openaire +2 more sources
IEEE Access, 2021 With the development of renewable energy technology, distributed power supply mode with multi energy and multi-directional power flow including utility grid, renewable energy and energy storage unit has gradually become a research hotspot.
Yanping Zhu +6 more
doaj +1 more source
Energies, 2019 Photovoltaic (PV) energy has been competitive in power generation as an alternative to fossil energy resources over the past decades. The installation of grid-connected solar energy systems is expected to increase rapidly with the fast development of the
Wenjie Liu +3 more
doaj +1 more source
A new modulation strategy on isolated battery charger with wide input and output voltage range
IET Power Electronics, 2023 A new wide voltage operation range isolated battery charger, which is composed of an asymmetric T‐type AC–DC power rectifier and a modified re‐configurable half bridge DC–DC power converter, is proposed in this paper.
Hurng‐Liahng Jou +5 more
doaj +1 more source
A Bidirectional Soft-Switched DAB-Based Single-Stage Three-Phase AC–DC Converter for V2G Application [PDF]
, 2019 In vehicle-to-grid applications, the battery charger of the electric vehicle (EV) needs to have a bidirectional power flow capability. Galvanic isolation is necessary for safety.
Baranwal, Rohit +4 more
core +2 more sources
Circuit Structure and Control Method to Reduce Size and Harmonic Distortion of Interleaved Dual Buck Inverter [PDF]
, 2020 A new circuit structure and control method for a high power interleaved dual-buck inverter are proposed. The proposed inverter consists of six switches, four diodes and two inductors, uses a dual-buck structure to eliminate zero-cross distortion, and ...
Cho, Min-Gi +4 more
core +1 more source
DC–DC conversion powering for the CMS tracker at SLHC [PDF]
Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2011 Abstract A tracker powering scheme based on DC–DC converters close to the detector modules can supply more power through thinner cables. This will allow to satisfy the increased power demands of tracking systems at the SLHC. This article describes the development of DC–DC converters for upgrades of the CMS pixel and tracking systems and addresses ...
L. Feld +5 more
openaire +1 more source
Energy Reports, 2020 For multi-applications, a novel universal switched-capacitor (SC) converter is proposed in this paper. The proposed converter consists of a rotation-type SC converter and a full-bridge circuit.
Kei Eguchi +3 more
doaj +1 more source
Power Factor Corrector with Bridgeless Flyback Converter for DC Loads Applications
Energies, 2018 Since power systems with a DC distribution method has many advantages, such as conversion efficiency increase of about 5⁻10%, cost reducing by about 15⁻20% and so on, the AC distribution power system will be replaced by a DC distribution one.
Sheng-Yu Tseng +2 more
doaj +1 more source
Evaluation of isolated DC/DC converter topologies for future HVDC aerospace microgrids [PDF]
, 2017 High performance power conversion equipment is currently gaining an increasing interest for aircraft applications. In particular, isolated bidirectional DC/DC converters are often proposed for modern HVDC aircraft distribution systems. For such reason an
Costabeber, Alessando +4 more
core +2 more sources