Results 71 to 80 of about 526,100 (292)
, 2011 The target fragmentation region of semi-inclusive deep inelastic scattering is described at leading twist, taking beam and target polarizations into account. The formalism of polarized and transverse-momentum dependent fracture functions is developed and
Anselmino, Mauro +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Mağallaẗ Al-kūfaẗ Al-handasiyyaẗThis study aims to experimentally investigate the performance of steel fiber-reinforced concrete deep beams with various sizes of square web-opening applied to shear and shear-bending control loading scenarios.
Dhyaa A. Al-Sattar, Jasim A. Abdulla
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Utilizing the Strut-and-Tie Model for the Design and Analysis of Deep Beams
Modelling in Civil Environmental EngineeringReinforced concrete deep beams, distinguished by a low shear span-to-depth ratio, exhibit complex, nonlinear strain distributions that render conventional beam theory inadequate.
Platon Mihai
doaj +1 more source
Effect of Heating on Simply Supported Reinforced Concrete Deep Beams
Diyala Journal of Engineering Sciences, 2015 This laboratory research is concerned with the behavior of reinforced concrete deep beams, being exposed to high temperatures for one time or more. Two types of mixing water are used, namely, drinkable water (tap water) and non-drinkable water (raw ...
Khattab Saleem Abdul-Razzaq
doaj +1 more source
Tensile force and bond stress of longitudinal reinforcemenet in heavily reinforced concrete beam [PDF]
, 2011 This dissertation presents an experimental study related to the tensile force and bond stress of longitudinal reinforcement in heavily reinforced concrete beam. The test variables in this study include the ratio of longitudinal and shear reinforcement.
Imran, Nik Farhanim
core
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source