Results 91 to 100 of about 19,827 (295)

A Reconfigurable Filter Using Defected Ground Structure for Wideband Common-Mode Suppression

open access: yesIEEE Access, 2019
A wideband common-mode (CM) suppression reconfigurable filter is proposed for high-speed all-pass differential circuits. The filter adopts three varactor-loaded compact defected ground structures (DGSs) to achieve continuous reconfigurability in its ...
Zhibin Zeng   +2 more
doaj   +1 more source

Design and fabrication of a novel multilayer bandpass fi lter with high-order harmonics suppression using parallel coupled microstrip fi lter

open access: yesETRI Journal, 2022
This study presents a novel multilayer structure of parallel coupled-line bandpass filtercentered at 2.42 GHz with a fractional bandwidth value of approximately 19.4%.
Esmaeil Fathi   +2 more
doaj   +1 more source

Low-energy, planar magnetic defects in BaFe2As2: nanotwins, twins, antiphase and domain boundaries [PDF]

open access: yes, 2013
In BaFe2As2, structural and magnetic planar defects begin to proliferate below the structural phase transition, affecting descriptions of magnetism and superconductivity.
Alam, Aftab   +3 more
core   +5 more sources

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

open access: yesAdvanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin   +2 more
wiley   +1 more source

Solitons: from Charge Density Waves to FFLO in superconductors

open access: yes, 2009
This short review aims to summarize on "What the Charge Density Waves can tell to other inhomogeneous states in strongly correlated systems, particularly to spin-polarized superconductors".
Brazovski   +10 more
core   +4 more sources

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

open access: yesAdvanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira   +4 more
wiley   +1 more source

Harmonic-Rejection Compact Bandpass Filter Using Defected Ground Structure for GPS Application

open access: yesActive and Passive Electronic Components, 2014
A miniaturized bandpass filter (BPF) using defected ground structure (DGS) resonator with the characteristic of harmonic rejection is developed in this paper.
Haiwen Liu   +5 more
doaj   +1 more source

Packaging of Macroscopic Material Payloads: Needs, Challenges, Concepts, and Future Directions

open access: yesAdvanced Engineering Materials, EarlyView.
This review introduces a unified framework that decomposes any macroscopic packaging system into the payload, packaging material, and packaging strategy and combines them into a conceptual packaging equation: packaging strategy = payload + packaging material.
Venkata S. R. Jampani, Manos Anyfantakis
wiley   +1 more source

Influence of Sample Preparation and Processing Procedures on the Thermal Diffusivity of MgO‐C Refractories

open access: yesAdvanced Engineering Materials, EarlyView.
The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan   +4 more
wiley   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Home - About - Disclaimer - Privacy