Results 11 to 20 of about 399 (194)

Microstructure and mechanical properties of HA/Ti composite coatings applied by detonation spraying [PDF]

open access: yesҚарағанды университетінің хабаршысы. Физика сериясы, 2023
This work presents the results of experimental studies of the structure and mechano-tribological properties of composite coatings based on hydroxyapatite (HA) and titanium in different ratios (wt. %): 30HA-70Ti, 50HA-50Ti, 70HA-30Ti.
Ж.Б. Сағдолдина   +5 more
doaj   +2 more sources

Multicriteria optimization of heat-resistant coatings detonation spraying technology

open access: yesПроблеми трибології, 2023
The paper presents the multi-criteria optimization results of heat-resistant coatings detonation spraying technology. The following criteria for optimization of detonation spraying technology are chosen: critical deformation of coating fracture, adhesion-
E.K. Solovykh   +5 more
doaj   +1 more source

Effect of the detonation-spraying mode on the tribological properties of NiCr-Al2O3 coatings

open access: yesEurasian Journal of Physics and Functional Materials, 2021
The article presents the study results of detonation spraying parameters on the phase composition and tribological properties of NiCr-Al2O3 powder coatings. The spraying was carried out at a ratio of the acetylene-oxygen mixture O2/C2H2=1.856.
B.K. Rakhadilov   +4 more
doaj   +1 more source

Technology for restoration and repair of aircraft engine parts

open access: yesAviation, 2021
Problems of increasing the service life of compressor blades of aircraft gas turbine engines using detonation spraying technology are considered. The simulation of the parameters of the velocity and temperature of the particles of the sprayed material in
Serhii Nyzhnyk   +3 more
doaj   +1 more source

Obtaining functional-gradient Ti-HA coatings by detonation spraying

open access: yesҚарағанды университетінің хабаршысы. Физика сериясы, 2022
Functional-gradient titanium/hydroxyapatite (TiHA) coatings were obtained using detonation spraying technology to improve the structure and mechanical properties.
Ж.Б. Сағдолдина   +3 more
doaj   +1 more source

Study of the Structural-Phase State of Hydroxyapatite Coatings Obtained by Detonation Spraying at Different O2/C2H2 Ratios

open access: yesCrystals, 2023
This work studies the influence of the composition of an acetylene–oxygen explosive O2/C2H2 mixture on the structure and properties of hydroxyapatite coatings obtained by detonation spraying.
Daryn Baizhan   +6 more
doaj   +1 more source

Obtaining of hydroxyapatite coatings on a titanium substrate by detonation-gas spraying

open access: yesEurasian Physical Technical Journal, 2021
The article considers research results of the formation process of a hydroxyapatite coating on a titanium substrate during detonation spraying. Powders for sputtering and obtained coatings of hydroxyapatite were studied by Raman spectroscopy and X-ray ...
B.K. Rakhadilov   +6 more
doaj   +1 more source

Influence of the detonation-spraying mode on the phase composition and properties of Ni-Cr coatings

open access: yesEurasian Journal of Physics and Functional Materials, 2021
In work considers the results of studies of the phase composition and mechanical-tribological properties of Ni-Cr detonation coatings obtained at different values of the volume of filling the detonation barrel with an explosive acetylene-oxygen mixture ...
M. .. Maulet   +4 more
doaj   +1 more source

Observed Structure of Spray Detonations [PDF]

open access: yesThe Physics of Fluids, 1968
The propagation of a detonation wave in a tube containing a single stream of 2600-μ-diam diethylcyclohexane droplets dispersed in gaseous oxygen has been studied with streak and space resolved photography, special pressure transducers, and thin-film heat-transfer gauges.
Ragland, Kenneth W.   +2 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy