Results 1 to 10 of about 948,334 (268)

Using Regression Analysis for Automated Material Selection in Smart Manufacturing

open access: yesMathematics, 2022
In intelligent manufacturing, the phase content and physical and mechanical properties of construction materials can vary due to different suppliers of blanks manufacturers. Therefore, evaluating the composition and properties for implementing a decision-
Ivan Pavlenko   +6 more
doaj   +1 more source

Influence of Beam Power on Structures and Mechanical Characteristics of Electron-Beam-Welded Joints of Copper and Stainless Steel

open access: yesMetals, 2022
In this study, we present the results of electron-beam welding of joints with 304-L stainless steel and copper. The influence of the beam’s power on the structures and mechanical properties of the welded joints was studied; the experiments were realized ...
Darina Kaisheva   +8 more
doaj   +1 more source

Structural and Magnetic Properties of Hydrothermal Spinel Ni0.4Zn0.6Fe2O4 Ferrites [PDF]

open access: yesMaterials Research, 2015
Spinel ferrite powder with a nominal composition Ni0.4Zn0.6Fe2O4 was prepared by a hydrothermal method, following by sintering at 700 °C and 900 °C, respectively. The structural and magnetic properties of specimens are studied. It is found that the large
Yiwei Zhang   +3 more
doaj   +1 more source

Theoretical and technological aspects of production mechani‑cally alloyed powders for the production of coatings and products by additive methods

open access: yesЛитьë и металлургия, 2021
The established regularities of the formation of powders based on iron and nickel, obtained by the method of mechanical alloying and intended for the deposition of thermal spraying coatings, as well as the manufacture of products by layer‑by‑layer ...
F. G. Lovshenko   +2 more
doaj   +1 more source

Thermodynamic Modeling of Phase Composition of Si/Si Oxide Structures Obtained by Phase Separation of Nonstoichiometric Si Oxides

open access: yesЖурнал нано- та електронної фізики
The article investigates the effect of annealing temperature and initial stoichiometry of Si oxide in a wide range on the phase composition of Si/SiOx nanocomposites formed by phase separation induced by high-temperature annealing.
V. Naholenko, A. Sarikov, O. Ryzhko
doaj   +1 more source

NIOBIUM RECOVERY FROM TITANIUM TETRACHLORIDE PRODUCTION BY-PRODUCTS

open access: yesШәкәрім университетінің хабаршысы: Техника ғылымдар
This article presents the results of a study on the processing of industrial by-products from titanium tetrachloride production for the purpose of niobium extraction.
T. Sarsembekov   +4 more
doaj   +1 more source

Formation, Structure and Properties of Modified with Forsterite Microarc Oxidation Coating on Мл10 (ML10) Magnesium Alloy

open access: yesМеханика машин, механизмов и материалов, 2022
The structure, phase composition, microhardness, and adhesive strength of a coating on an МЛ10 (ML10) magnesium alloy modified with Mg2SiO4 forsterite during microarc oxidation (MAO) have been studied.
Aleksandr I. Komarov   +2 more
doaj   +1 more source

The Characters of Mo-MoSi2 Functionally Graded Coating

open access: yesHigh Temperature Materials and Processes, 2014
Mo-MoSi2 functionally graded coating on Mo substrate is prepared by siliconizing technology. The characters of Mo-MoSi2 functionally graded coating are analyzed by SEM, EDS, GDS and XRD. The result shows that Mo-MoSi2 functionally graded coating is dense
Zhang Ying-Yi   +3 more
doaj   +1 more source

Biomass as a Source of Energy in Iron Ore Agglomerate Production Process

open access: yesArchives of Metallurgy and Materials, 2014
Artykuł zawiera charakterystykę wybranych rodzajów biomasy, które mogą być uznane jako paliwo alternatywne w produkcji aglomeratów rudy żelaza. Wyselekcjonowane rodzaje biomasy poddano ocenie za pomocą analizy chemicznej, rentgenowskiej analizy fazowej ...
Fröhlichová M.   +3 more
doaj   +1 more source

Phase composition of Bi2O3 specimens doped with Ti, Zr and Hf [PDF]

open access: yesJournal of the Serbian Chemical Society, 2012
Powder mixtures of α-Bi2O3 containing 2, 5 and 10 mole % of TiO2, ZrO2 or HfO2 were homogenized, heated at 820ºC for 24 h and quenched in air. X-ray powder diffraction technique was used to characterize the prepared samples.
Poleti Dejan   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy