Results 11 to 20 of about 197,569 (311)
Development of a high strength Al-Mg2Si-Mg-Zn based alloy for high pressure die casting [PDF]
, 2015 A high strength Al-Mg2Si-Mg-Zn based alloy has been developed for the application in high pressure die casting to provide improved mechanical properties.
Badal +22 more
core +1 more source
Journal of Materials Research and Technology, 2023 In this research, ZL104 aluminum alloy flywheel housing with large wall-thickness difference and complex shape were formed via local-loading squeeze casting.
Qiang Chen +7 more
doaj +1 more source
Microstructural characteristics of diecast AlMgSiMn alloy [PDF]
, 2014 Solidification and microstructural characteristics of Al-5wt.%Mg-1.5wt.%Si-0.6wt.%Mn- 0.2wt.%Ti alloy have been investigated in high pressure die casting. The average size of dendrites and fragmented dendrites of the primary α-Al phase formed in the shot
Fan, ZY, Ji, SX, Wang, Y, Watson, D
core +1 more source
Opportunities and challenges of Chinese die-casting market [PDF]
China Foundry, 2004 The present status and prospectives of Chinese die-casting market were commented. In 2003, the total output of die castings in the whole country was 708 000 tons, in which the output of Al-alloy, Zn-alloy, Mg-alloy, Cu-alloy die casitngs were 474 600 ...
Caifei SONG
doaj
Evaluation of porosity in Al alloy die castings [PDF]
, 2012 Mechanical properties of an Al-alloy die casting depend significantly on its structural properties. Porosity in Al-alloy castings is one of the most frequent causes of waste castings.
J. Havlíčková, J.Cech, M. Říhová
core +2 more sources
Effect of vacuum on porosity and mechanical properties of high-pressure die-cast pure copper [PDF]
China Foundry, 2019 Pure copper tensile bars were produced by conventional die casting (HPDC) and vacuum-assist die casting (VADC) processes. Porosity and mechanical properties were investigated by using optical microscopy (OM), scanning electron microscopy (SEM), energy ...
Hong-mei Yang +2 more
doaj
An inverse model to determine the heat transfer coefficient and its evolution with time during solidification of light alloys [PDF]
, 2008 Infra-red probes linked to pyrometric chains and thermocouple arrays have been used to accurately determine both casting and die surface temperatures during the solidification of an aluminium A380 alloy and the magnesium alloy AZ91D. An inverse model was
Griffiths C. P. +5 more
core +4 more sources
Metals, 2020 Rare earth (RE) additions are capable of refining the α-Al phase as well as modifying the eutectic Si particles of alloys. The cooling rate in casting process should be carefully concerned when the Al-Si alloys are refined and modified by adding RE ...
Longfei Li +4 more
doaj +1 more source
Investigation on microstructure and mechanical properties of squeeze cast Al-Si alloys by numerical simulation [PDF]
, 2014 Since squeeze casting process is considered as a new technology for light alloys like aluminum and magnesium, more basic research is required for a scientific understanding of the practice.
Kiaee, Mona +3 more
core +1 more source
Development of vacuum die-casting process [PDF]
China Foundry, 2009 The vacuum die-casting process, started 25 years ago in Japan, has been widely applied. This technology contributes very much to improvement of castings quality.
Masashi Uchida
doaj