Results 31 to 40 of about 189,211 (301)
Hyperbranched phosphorus flame retardants: multifunctional additives for epoxy resins [PDF]
, 2019 We successfully synthesized multifunctional P-based hyperbranched polymeric flame retardants (hb-FRs) with varying oxygen-to-nitrogen (O : N) content and characterized them via 1H and 31P NMR and GPC.
Battig, A. +3 more
core +2 more sources
Specific heat determination of lateritic ore by differential scanning calorimetry
Minería y Geología, 2021 To evaluate, design, or characterize any thermo physical process such as drying, the homonymous properties of materials involved in such process are decisive.
Carlos Zalazar Oliva +4 more
doaj
Analysis of the molecular mobility of collagen and elastin in safe, atheromatous and aneurysmal aortas [PDF]
, 2012 Aim of the study : In this study, we propose to use a thermal technique, Differential Scanning Calorimetry (DSC) to follow the evolution of elastin and collagen in safe and pathological cardiovascular tissues.
Dandurand, Jany +7 more
core +2 more sources
Thermal Activation of Copper Oxide Based upon the Copper Hydrotalcites of the Type CuxZn6-xCr2(OH)16(CO3).4H2O [PDF]
, 2003 A combination of DSC and high resolution DTG coupled to a gas evolution mass spectrometer has been used to study the thermal properties of a series of Cu/Zn hydrotalcites of formulae CuxZn6-xAl2(OH)16(CO3).4H2O where x varied from 6 to 0.
Ding, Zhe, Frost, Raymond
core +2 more sources
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Evaluation of peritoneal tissue by means of differential scanning calorimetry (DSC)
Folia Histochemica et Cytobiologica, 2012 Abdominal surgeries alter the integrity of the peritoneal layer and cause imbalances among immunological, inflammatory and angiogenic mechanisms within the tissue.
Łukasz Pietrzyk +4 more
doaj +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Advanced Engineering Materials, EarlyView.Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Medžiagotyra, 2020 Pelt obtained by deliming with peracetic acid can be chromed after additional treatment with sodium chloride or oxalic acid solution, or directly tanned using synthetic tannins.
Virgilijus VALEIKA
doaj +1 more source
Thermal Characterization of Phase Change Materials by Differential Scanning Calorimetry: A Review
Applied Sciences, 2022 The use of phase change materials (PCMs) in thermal energy storage (TES) applications as a system that can fill the gap between the energy supply and demand has sharply increased over recent years.
Hazhir Fatahi +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source