Engineering design project : series 1 [PDF]
, 2017 This book is a compilation of engineering design projects which illustrates a detail explanation on the design process including all tools and methods involved in each design stage.
core
Soft computing approaches of direct torque control for DFIM Motor's
Cleaner Engineering and TechnologyConventional Direct Torque Control (DTC) is widely used for torque and speed control in doubly-fed induction machines (DFIM). However, it has notable drawbacks, including high torque and flux ripples, which generate acoustic noise and reduce system ...
Zakariae Sakhri +6 more
doaj +1 more source
Direct Torque Control of 5-Phase 10/8 Switched Reluctance Motors
Iranian Journal of Electrical and Electronic Engineering, 2009 A switched Reluctance motor (SRM) has several desirable features, including simple construction, high reliability and low cost. However, it suffers from large torque ripple, highly non-uniform torque output and magnetization characteristics and large ...
M. R. Feyzi, Y. Ebrahimi
doaj
Control of a Wind Turbine based on DFIG by Improved Direct Torque Control using Fuzzy Logic
Revue des Énergies RenouvelablesThe capacity of doubly-fed induction generators (DFIGs) to regulate both active and reactive power makes them a well-liked option for wind turbines. Direct Torque Control (DTC) is a commonly employed method for managing DFIGs, but it has limitations such
Karim Fathi Sayeh +5 more
doaj +1 more source
PENGGUNAAN PCI 1710 SEBAGAI MEDIA INTERFACE UNTUK IMPLEMENTASI METODE DIRECT TORQUE CONTROL UNTUK PENGATURAN KECEPATAN MOTOR INDUKSI TIGA PHASA [PDF]
, 2010 Penelitian ini mengobservasi penggunaan PCI 1710 sebagai interaface untuk implementasi metode pengaturan kecepatan motor induksi tiga fasa berbasis Direct torque Control (DTC) .
Wahjono, Endro
core
Virtual-Sensor-Based Maximum-Likelihood Voting Approach for Fault-Tolerant Control of Electric Vehicle Powertrains [PDF]
, 2013 International audienceThis paper describes a sensor fault-tolerant control (FTC) for electric-vehicle (EV) powertrains. The proposed strategy deals with speed sensor failure detection and isolation within a reconfigurable induction-motor direct torque ...
Benbouzid, Mohamed +3 more
core +3 more sources
Improved DTC of Induction Motor with Fuzzy Controller [PDF]
E3S Web of ConferencesDTC, also known as Direct Torque Control, is a technique employed in variable frequency drives for regulating the torque and speed of three-phase AC electric motors. This method entails determining an approximation of the motor’s magnetic flux and torque
Manivasagam +3 more
doaj +1 more source
Active Speed Compensation Method of Direct Torque Control System and Stability Analysis
Advances in Mechanical Engineering, 2015 By analyzing characteristics of the DTC (direct torque control) system in electrical driving system, a shortcoming of the classical DTC method is to point out that it is unable to decouple the mutual interference between torque and speed, so that when a ...
Rui Li, Chao-nan Tong, Xu Yang
doaj +1 more source
Model predictive control of electromagnetic torque in permanent magnet synchronous machines [PDF]
, 2013 University of Technology, Sydney. Faculty of Engineering and Information Technology.This study focuses on the development of novel model predictive control method for PMSM drive system.
Wang, T
core
Advances in Electrical and Computer Engineering, 2010 In this study, direct torque control (DTC) of a permanent magnet synchronous motor is realized with a sensorless speed control technique without using an observer.
BEKIROGLU, N., OZCIRA, S.
doaj +1 more source