Results 1 to 10 of about 3,160 (164)

The optimization algorithm for application in directional drilling trajectories of energy field

open access: yesEnergy Reports, 2022
Recently, the directional drilling technology (DDT) has been extensive used in many energy field such as coal geological exploration, gas drainage and artificial freezing engineering etc.
Shu-jie Liu   +3 more
doaj   +3 more sources

Directional deflection equations for steerable drilling tools and the control mechanism of wellbore trajectory

open access: yesPetroleum Exploration and Development, 2017
: To meet the wellbore trajectory control requirements for all kinds of steering drilling modes, the directional deflection equations for steerable drilling tools and the process control method for wellbore trajectory were proposed and an application ...
Xiushan LIU
doaj   +3 more sources

Quantitative assessment of source rock maturity with multiple aromatic parameters: a case study of Mesozoic source rocks in Yingen-Ejinaqi Basin

open access: yesShiyou shiyan dizhi, 2022
Aromatic parameters have been widely applied to assess the maturity of organic matters. Some parameters may not only be affected by maturation, but also more affected by organic matter source, sedimentary environment, etc.
Zhijun CHEN   +6 more
doaj   +1 more source

Experimental study on directional drilling with high pressure nitrogen in soft-fragmentized coal seam of Wangpo Coal Mine

open access: yesMeikuang Anquan, 2022
Aiming at the characteristics of poor cementation and broken seam in Wangpo Coal Mine, the pneumatic directional drilling test of soft-fragmentized coal seam with high-pressure nitrogen slag discharge was carried out.
SUN Yongxin   +5 more
doaj   +1 more source

Research on key technology of sliding drag reduction drilling along ultra-long directional hole in coal seam

open access: yesMeikuang Anquan, 2022
The gas control in large panel of underground coal mine objectively requires the length of ultra-long directional drilling along the coal seam to reach more than 3 000 m, however, restricted by the current directional drilling technology and equipment in
XU Chao, JIANG Lei, LI Quanxin, FANG Jun, CHEN Pan, LIU Zhi
doaj   +1 more source

Effect Evaluation of Nanosilica Particles on O/W Emulsion Properties

open access: yesGeofluids, 2022
O/W emulsion reinforced by nanosilica particle has good application in hydrocarbon development. However, there are few reports on the influence of nanosilica particles on the oil-water interface of O/W emulsion.
Guanzheng Qu   +4 more
doaj   +1 more source

Research on rotary geosteering drilling technology and equipment in underground coal mine

open access: yesMeitan kexue jishu, 2022
In view of the limitations of directional drilling technology and equipment for underground gas drainage in coal mining areas, such as low degree of automation, low drilling ratio of target formation, slow drilling rate of rock formation, and small ...
Ke YAO   +7 more
doaj   +1 more source

Directional drilling technologies equipment and application for hard rock in underground coal mines

open access: yesMeikuang Anquan, 2021
According to the problems existing in directional drilling of hard rock in coal mines, such as low drilling efficiency, easy bearing pressure in deep hole drilling and easy damage of drilling tools in hole, based on the analysis of the causes of the ...
DOU Xuqian, WANG Li
doaj   +1 more source

Technical difficulties and innovation in the Jiangyin Yangtze River crossing project of 3300 m HDD

open access: yesNatural Gas Industry B, 2014
The Jiangyin Yangtze River Crossing Project sets up a record with the length of horizontal directional drilling (HDD) of 3300 m in the world. Inevitably, many technical difficulties might exist in pilot hole docking, reaming torque, property requirement ...
Wu Yiquan   +4 more
doaj   +1 more source

Semantic-Preserving Mesh Direct Drilling [PDF]

open access: yes2010 Shape Modeling International Conference, 2010
Advances in modeling of discrete models have allowed the development of approaches for direct mesh modeling and modification. These tools mainly focus on modeling the visual appearance of the shape which is a key criterion for animation or surgical simulation.
Ruding Lou   +6 more
openaire   +6 more sources

Home - About - Disclaimer - Privacy