Results 91 to 100 of about 232,000 (307)

Laboratory measurements of factors affecting discharge capacity of prefabricated vertical drain materials

open access: yes, 2016
The discharge capacity is a critical parameter controlling the performance of Prefabricated Vertical Drains (PVDs). The laboratory measurement of the discharge capacity is of the upmost importance when it comes to assessing the performance of proposed ...
Leong, Melvyn   +4 more
core   +1 more source

Premature Discharge from Intensive Care with Special Reference to Night-Time Discharge and Capacity Transfers

open access: yes, 2023
Objectives   Intensive care is an expensive and limited resource, and when a demand supply mismatch between available beds and influx of patients occurs, one temporary measure is to discharge a patient to make room for the new admission.
Parenmark, Fredric
core   +1 more source

Slip Localization Intensification Mediated by Grain Boundary Sliding in a Polycrystalline Nickel‐Based Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat   +5 more
wiley   +1 more source

Molten Salt Synthesis of Disordered Spinel LiNi0.5Mn1.5O4 with Improved Electrochemical Performance for Li-ion Batteries

open access: yesInternational Journal of Electrochemical Science, 2018
Disordered spinel LiNi0.5Mn1.5O4 (LNMO) was successfully synthesised via a molten-salt method using a mixture of LiOH⋅H2O and LiNO3 salts. The precursor was annealed at 750, 850 or 950 °C for 12 h, and the effects of calcination temperature on the ...
Nabilah Mokhtar   +2 more
doaj   +1 more source

Insight Into Li/S Batteries: Elementary Kinetic Modeling and Impedance Simulation

open access: yes, 2012
The lithium-sulfur (Li/S) battery is one of the most promising systems for portable electrochemical energy storage [1]. The complex redox chemistry of sulfur, the large number of soluble intermediates and the dissolution and precipitation of ...
Fronczek, David Norman   +1 more
core  

Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites

open access: yesAdvanced Engineering Materials, EarlyView.
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter   +9 more
wiley   +1 more source

New bed configurations and discharge timing policies: A hospital‐wide simulation

open access: yes, 2022
Objective: Optimising patient flow is becoming an increasingly critical issue as patient demand fluctuates in healthcare systems with finite capacity.
Hamed Hassanzadeh   +9 more
core   +1 more source

Home - About - Disclaimer - Privacy